Ordering number:ENN6195A
Monolithic Digital IC
LB1934T
3V Camera 1.5-Channel Driver
Overview
The LB1934T is a low-volt...
Ordering number:ENN6195A
Monolithic Digital IC
LB1934T
3V Camera 1.5-Channel Driver
Overview
The LB1934T is a low-voltage, low-saturation forward/ reverse driver IC with built-in 1.5-channel bridge. Its compact, low-profile package makes it ideal for use in compact cameras powered by 3V lithium batteries. Using direct microcontroller drive, it is possible to control standby, forward rotation, reverse rotation, and braking of two motors for film rewind and lens drive by means of only three control signals. The 0.5-channel section of the 1.5channel bridge can be divided into sink/source output, allowing configurations such as 1-channel bridge + sink output + source output.
Package Dimensions
unit:mm 3246-TSSOP20
[LB1934T]
20 11
0.5 4.4 6.4 0.08 (1.0) 1.2max
6.5
Features
Low voltage drive possible. When using same power supply for V CC and V S : VCC=VS=1.4V min. When using separate power supply for VCC and VS : VS=1.0V min., VCC=1.4V min. Low saturation voltage : residual voltage (upper side
transistor + lower side
transistor) =0.5V typ. at Io=1A. Zero power dissipation in standby mode. Direct microcontroller drive possible (any strength relationships of voltage supported between microcontroller control signal and VCC or VS). Logic power supply and motor power supply can be supplied at separate pins. Built-in thermal protection circuit. Number of control signals can be optimized for the set. “2-motor control” or “1-motor + 2-load control” can be implemented by...