MC12093

Order this document by MC12093/D ÷2, ÷4, ÷8 MC12093 1.1GHz Low Power Prescaler with Stand-By Mode The MC12093 is a single modulus prescaler for low power frequency division of a 1.1 GHz high frequency input signal. Motorola’s advanced MOSAIC™ V technology is utilized to acheive low power dissipation of 6.75 mW at a minimum supply voltage of 2.7 V. On–chip output termination provides output current to drive a 2.0 pF (typical) high impedance load. If additional drive is required for the prescaler output, an external resistor can be added parallel from the OUT pin to GND to increase the output power. Care must be taken not to exceed the maximum allowable current through the output. Divide ratio control inputs SW1 and SW2 select the required divide ratio of ÷2, ÷4, or ÷8. Stand–By mode is featured to reduce current drain to 50 µA typical when the standby pin SB is switched LOW disabling the prescaler. MECL PLL COMPONENTS ÷2, ÷4, ÷8 LOW POWER PRESCALER WITH STAND–BY MODE SEMICONDUCTOR TECHNICAL DATA 8 1 1.1 GHz Toggle Frequency Supply Voltage 2.7 V to 5.5 Vdc Low Power 3.0 mA Typical Operating Temperature –40 to 85°C Divide by 2, 4 or 8 Selected by SW1 and SW2 Pins On–Chip Termination 8 D SUFFIX PLASTIC PACKAGE CASE 751 (SO–8) MOSAIC V is a trademark of Motorola 1 FUNCTIONAL TABLE SW L H L H SW2 L L H H Divide Ratio 8 4 4 2 SD SUFFIX PLASTIC PACKAGE CASE 940 (SSOP–8) PIN CONNECTIONS NOTES: 1. SW1 & SW2: H = (VCC – 0.5 V) to VCC; L = Open. 2. SB: H = 2.0 V...