MITSUBISHI (Dig./Ana. INTERFACE)
M62258FP
GENERAL PURPOSE BATTERY CHARGER CONTROL IC
DESCRIPTION
The M62258FP is desig...
MITSUBISHI (Dig./Ana. INTERFACE)
M62258FP
GENERAL PURPOSE BATTERY CHARGER CONTROL IC
DESCRIPTION
The M62258FP is designed as general purpose battery charger control. The M62258FP has function which require for the batterycharge control on single chip. Not only the combination of M62258 and microcomputer capable of handing battery charge control, but also it is capable of monitoring battery temperature, prevent from over current or voltage, using minimal peripherals. It also has feedback function to the primary side of SW power supply, which can used to control feedback of charge current and output voltage.
PIN CONFIGURATION (TOP VIEW)
GND 1 P.C 2 MSW 3 REF 4 IN1 5 IN2 6
16 VDET 15 IDET 14 CS 13 CK 12 DI 11 VB 10 VCC 9 VDD
FEATURES
Built-in 3 wire serial data interface function for MCU. Built-in multiplexer and level magnification circuit with 2input ports. Built-in low input/output operation 5V voltage
regulator function.
(Pre drive type)
ISENSE 7 DOUT 8
16P2N-A
Built-in charge current/output voltage control circuit.
APPLICATION
Video camera, hand held telephone and general battery charger for other digital equipment
BLOCK DIAGRAM
VDET 16
IDET 15
VCC 10
VB 11
VDD 9
MSW 3
P.C
2 VOLTAGE
REGULATOR MAIN SW CIRCUIT 9 1
VOLTAGE CONTROL OP
VOLTAGE CONTROL CIRCUIT
7 Amp1 5
ISENSE
IN1
CURRENT CONTROL OP
CURRENT CONTROL CIRCUIT
SERIAL/PARALLEL CONVERSION CIRCUIT Amp2 6 4 3 1 IN2 REF
1 GND
14 CS
12 DI
13 CK
8 DOUT
( 1 / 7 )
MITSUBISHI (Dig./Ana. INT...