2 Mountable. POD3-J-DFS111 Datasheet

POD3-J-DFS111 Mountable. Datasheet pdf. Equivalent


Part POD3-J-DFS111
Description Push-Pull Complete Locking Coaxial Connectors (PC Card Type 2 Mountable)
Feature Push-Pull Complete Locking Coaxial Connectors (PC Card Type 2 Mountable) POD3 Series Board Mounting.
Manufacture Hirose Electric
Datasheet
Download POD3-J-DFS111 Datasheet


Push-Pull Complete Locking Coaxial Connectors (PC Card Type POD3-J-DFS111 Datasheet
Recommendation Recommendation Datasheet POD3-J-DFS111 Datasheet




POD3-J-DFS111
Push-Pull Complete Locking Coaxial Connectors (PC Card Type 2 Mountable)
POD3 Series
sFeatures
1. Excellent push-pull complete locking
method for ease of operation
The connector coupling portion uses a Hirose Electric
original push-pull complete locking system.
1) A sure lock is obtained by holding the connector outside
tube portion and just giving it a light push.
2) Positive lock prevents easy disconnection.
To remove the connector, just hold the connector outside
tube portion and pull for a simple release of the lock
sApplications
Wireless LAN cards, GPS cards, and miniature wireless
communications devices.
sFunction Diagrams
Jack Side
sJack
POD3-J-DFS111
sReceptacle
POD3-R-1
Board Mounting Example
2. Type II PC Card Mountable
The receptacle thickness is 3.9 mm which permits
mounting to the back side of a type II card.
(Note) that at the time of card mounting, use of 0.3mm offset of the board mounting
surface from the card center line will result in the same card center axis and
connector center axis.
3. High Degree of Matching
The top-touch system used for the coupling method
achieves high frequency performance from 0 to 3 GHz
with a V.S.W.R. of 1.3 or less.
4. Ultra-Miniature
As a complete locking type, this series achieves a size
reduction of approximately 50% in the direction of the
diameter as compared to our original POD1 Series.
5. Accommodates Ultra-Fine Cable
These connectors accommodate the use of ultra-fine
coaxial Teflon cable which permits high-density wiring
inside equipment.
Ø1.48 (single-layer shielded cable)
....CO-6F FH-SB manufactured by Hitachi Cable, Ltd.
....DFS111-UL1979 manufactured by Junkosha Co., Ltd.
Plug Side
sPlug Receptacle
POD3-PR-1
sConversion Adapter
(Coupling portion: SMA side jack - POD3 side jack)
HRMJ-POD3J
sConversion Adapter
(Coupling portion: SMA side jack - POD3 side plug)
HRMJ-POD3P
B23



POD3-J-DFS111
s Product Specifications
Ratings
Nominal characteristic impedance
Voltage
Frequency
50 ohms
100 V AC
DC to 3 GHz
Operating temperature
Operating humidity
-30C° to +85C°
95% max.
Item Specification
Condition
1. Contact resistance
Inner : 10 m ohms max.
Outside: 5 m ohms max.
100 mA max.
2. Insulation resistance
500 M ohms min.
250 V DC
3. Withstanding voltage
No flashover or insulation breakdown.
300 V AC / 1 minute
4. V.S.W.R.(*)
1.3 max.
DC to 3 GHz
5. Female contact retention 0.2 N min.
Measured with a Ø0.3 pin gauge
6. Insertion and withdrawal force (plug) 1.96 N min.
With corresponding connector
7. Durability (Insertion/withdrawal) Contact resistance: Amount of change 10 m ohms max. 250 cycles
8. Vibration
No electrical discontinuity of 1µs or more
No damage, cracks, or parts looseness.
Frequency: 10 to 500 Hz, single amplitude of 0.75 mm or
acceleration of 98 m/s2(peak), 2 hours in each of the 3 directions.
9. Shock
No electrical discontinuity of 1µs or more
No damage, cracks, or parts looseness.
Acceleration of 490 m/s2, 11 ms duration, sine half-wave
waveform, 10 cycles in each of the 3 axis
10. Humidity (Steady state)
Insulation resistance 100 M ohms min. (at high humidity)
500 M ohms min. (when dry)
240 hours at temperature of 25ç to 65ç and humidity of
No damage, cracks, or parts looseness.
90% to 96%
11. Temperature cycle
No damage, cracks, or parts looseness.
Temperature: -55°C ¡ 5 to 35°C ¡ 85°C ¡ 5 to 35°C
Time:
30 min ¡ Within 5 min ¡ 30 min. ¡ Within 5 min
Cycles:
5
12. Salt spray
No marked corrosion
Exposed to density 5% salt water for 48 hours
*Voltage standing wave ratio (V.S.W.R.) measuring system.
The above voltage standing wave ratio (V.S.W.R.) standard value is measured in the measuring system as shown below.
Network Analyzer
Test Set
Test Port
Test Port Cable
D.U.T Termination
Note1: The cable connector is measured with double ended 10cm cable assembly.
Note2: The printed circuit board connector is mounted on the 50 ohms PCB, to
which Hirose's adaptor is connected.
sMaterials
part
Body
Insulator
Female inner contact
Male vinnerr contact
Spring coil
Heat-shrink tubing
Material
Brass/Phosphor bronze
PTFE
Beryllium copper
Phosphor bronze
Piano wire
Polyolefin
Finish
Gold and nickel plating/Gold plating
——————
Gold plating
Gold plating
Nickel plating
——————
s Ordering Information
B24
POD3 – [ ] [ ]
q we
q Series name: POD3
w Connector types
J : Jack
R : Receptacle
PR : Plug receptacle
e Applicable cable or suffix
DFS111: CO-6F FH-SB manufactured by
Hitachi Cable, Ltd.
DFS111-UL1979 manufactured by
Junkosha Co., Ltd.







@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site (Privacy Policy & Contact)