NC7WB3306

NC7WB3306 TinyLogic UHS 2-Bit Low Power Bus Switch May 2000 Revised September 2003 NC7WB3306 TinyLogic UHS 2-Bit Low Power Bus Switch General Description The NC7WB3306 is a 2-bit ultra high-speed CMOS FET bus switch with TTL-compatible active LOW control inputs. The low On Resistance of the switch allows inputs to be connected to outputs with minimal propagation delay and without generating additional ground bounce noise. The device is organized as a 2-bit switch with independent bus enable (OE) controls. When OE is LOW, the switch is ON and Port A is connected to Port B. When OE is HIGH, the switch is OPEN and a high-impedance state exists between the two ports. Control inputs tolerate voltages up to 5.5V independent of VCC. Features s Space saving US8 surface mount package s MicroPak leadless package s Typical 3Ω switch resistance at 5.0V VCC s Minimal propagation delay through the switch s Power down high impedance input/output s Zero bounce in flow through mode. s TTL compatible active LOW control inputs s Control inputs are overvoltage tolerant Ordering Code: Product Order Number Package Code WB06 U3 Package Description Supplied As Number Top Mark 8-Lead US8, JEDEC MO-187, Variation CA 3.1mm Wide 3k Units on Tape and Reel 8-Lead MicroPak, 1.6 mm Wide 5k Units on Tape and Reel NC7WB3306K8X MAB08A NC7WB3306L8X MAC08A TinyLogic is a registered trademark of Fairchild Semiconductor Corporation. MicroPak is a trademark of Fairchild Semiconductor Corporation. © 2003...