Upstream CATV Driver Amplifier
19-1331; Rev 1; 6/98
KIT ATION EVALU E L B A IL AVA
Upstream CATV Driver Amplifier
____________________________Feature...
Description
19-1331; Rev 1; 6/98
KIT ATION EVALU E L B A IL AVA
Upstream CATV Driver Amplifier
____________________________Features
o Single +5V Supply o Output Level Ranges from Less than 8dBmV to 62dBmV, in 1dB Steps o Gain Programmable in 1dB Steps o 350mW Typical Power Dissipation o Transmit-Disable Mode o Two Shutdown Modes
________________General Description
The MAX3532 is a programmable power amplifier for use in upstream cable applications. The device outputs up to 62dBmV (continuous wave) through a 1:2 (voltage ratio) transformer when driven with 36dBmV at its input. It features variable gain, which is controlled via a 3-wire digital serial bus and available in 1dB steps. The operating frequency ranges from 5MHz to 42MHz. The MAX3532 offers three operating modes: high power, low noise, and transmit disable. High-power mode achieves the highest output levels, while low-noise mode achieves the lowest output noise when driving lower output levels. Transmit disable mode places the device in a high-isolation state with minimum output noise, for use between bursts in TDMA systems. Two power-down modes are also available. Software shutdown mode permits power-down of all analog circuitry while maintaining the programmed gain setting. Shutdown mode disables all circuitry and reduces current consumption below 10µA. The MAX3532 comes in a 36-pin SSOP package screened for the extended-industrial temperature range (-40°C to +85°C).
MAX3532 †
_______________Ordering Information
PART MAX3...
Similar Datasheet