WD1003

WD1002 WD1003 WD1002 WD1003 USER’S GUIDE 800-1910 (REV. 4-87) DOCUMENT SCOPE This document describes the hardware and software installation of the following boards: WD1002-WAH Winchester Disk Controller WDl002-WA2 Winchester/Floppy Disk Controller WDl003-WAH Winchester Disk Controller WDl003-WA2 Winchester/Floppy Disk Controller NOTE These controllers are designed for use in IBM Personal computer ATs or other AT-compatible computers with a 16bit data bus. The use of the term controller refers to all boards described within this document. When a specific reference is made to a particular board. the appropriate WD part number is used. 4. Attach 34-pin control connector pin 1 to J1 (J5 for WDl002-WA2 or WDl003-WA2) pin 1. Pin 1 is in the lower left hand corner of J1. Pin 1 is in the upper left hand corner of J5. 5. Connect control cable to drive. 6. Attach 20-pin data connector to J2 (drive C or 1) for the WD1002-WAH or WD1003-WAH (J4 for WD1002WA2 or WD1003-WA2). 7. Attach 20-pin data connector to J3 (Drive D or 2). 8. Connect data cables to drives. 9. Attach 34-pin floppy cable connector to J1. Connect cable to floppy drive. This step applies to WD1002-WA2 and WDl003-WA2 users only. 10. Attach Winchester activity LED connector to J6 for all controllers except the WDl002-WAH. The reference designator for the Winchester activity LED connector on the WD1002-WAH is J4. 11. Install the controller board into the expansion slot. Make sure that the board is seated properly by pressi...