Document
www.DataSheet4U.com
KAB-S6-LTM12C275
Short Form Description
JUMPtec®
...always a JUMP ahead!
KAB-S6-LTM12C275 is used to connect Toshiba LTM12C275 type panels to JUMPtec's JIPA System. Panel Type is 18-bit TFT SVGA. Power supply is 5V Pinout X4: ( fitting connector: molex 51021-0700) Pin: Name: Function: 1 BRIGHT Analog Output 0..5V for example to control CCFL brightness via Software (CCFL-Inverter must support this function) 2 REF internal use only 3 I2DAT internal use only 4 I2CLK internal use only 5 SW_BACK Power output for external CCFL Inverter, max.current 1A, default set to 12V, can also be set to 5V / 3.3V (described later) 6 GND GND 7 SW_VDD Panel supply voltage, in this case 5V, for reference only Note: Do not reference on the cable colors since they may vary Possible configurations: Backlight voltage Jumper R7 shorted = 3.3V Backlight Jumper R8 shorted = 5V Backlight Jumper R9 shorted = 12V Backlight !! Caution !! : Never short any of R7, R8 and R9 at the same time! This will cause damage to the system!
w
w
w
.D
a
S a t
e e h
U 4 t
.
m o c
© JUMPtec® Industrielle Computertechnik AG * Brunnwiesenstraße 16 * D-94469 Deggendorf document: kb ltm12C275.doc
page 1 of 1 pages last changend on 8-Mrz-00
.