DatasheetsPDF.com

DC/DC Converters. D221 Datasheet

DatasheetsPDF.com

DC/DC Converters. D221 Datasheet






D221 Converters. Datasheet pdf. Equivalent




D221 Converters. Datasheet pdf. Equivalent





Part

D221

Description

D200 Series / DC/DC Converters



Feature


D200 Series Single & Dual Output Miniatu re, 2W SIP DC/DC Converters Electrical Specifications Specifications typical @ +25°C, nominal input voltage & rate d output current, unless otherwise note d. Specifications subject to change wi thout notice. Input Key Features: Pa rameter Conditions Min. Typ. Max. 5 .5 13.2 26.4 52.8 0.3 Units ● 2W Ou tput Power ● Miniature SIP .
Manufacture

MicroPower Direct

Datasheet
Download D221 Datasheet


MicroPower Direct D221

D221; Case Input Voltage Range ● Single & Du al Outputs ● 1,000 VDC Isolation Inpu t Filter ● >2 MHour MTBF Reverse Pola rity Input Current Output ● 28 Standa rd Models ● Industry Standard Pin-Out Parameter Output Voltage Accuracy Outp ut Voltage Balance Line Regulation Load Regulation Ripple & Noise (20 MHz) Out put Power Protection Temperature Coef cient Output Short Circuit 5.


MicroPower Direct D221

VDC Input 4.5 5.0 12 VDC Input 10.8 12. 0 24 VDC Input 21.6 24.0 48 VDC Input 4 3.2 48.0 Internal Capacitor VDC A Uni ts % % % mV P - P % %/ºC Conditions Min. Typ. ±1.0 Max. ±3.0 ±1.0 Dua l Output , Balanced Loads For Vin Chang e of 1% ±1.2 See Model Selection Guide 120 75 ±0.02 Momentary (0.5 Sec.) Co nditions 60 Seconds 500 VDC 100 kHz, 1V Min. 1,000 1,000 60 125.


MicroPower Direct D221

Min. Ambient Case -40 Typ. +25 Max. +85 +100 +125 95 Typ. Max. General Parame ter Isolation Voltage Isolation Resista nce Isolation Capacitance Switching Fre quency Units VDC MΩ pF kHz Units ºC C ºC % Environmental Parameter Opera ting Temperature Range Operating Temper ature Range Storage Temperature Range C ooling Humidity Conditions -40 Free Ai r Convection RH, Non-c.

Part

D221

Description

D200 Series / DC/DC Converters



Feature


D200 Series Single & Dual Output Miniatu re, 2W SIP DC/DC Converters Electrical Specifications Specifications typical @ +25°C, nominal input voltage & rate d output current, unless otherwise note d. Specifications subject to change wi thout notice. Input Key Features: Pa rameter Conditions Min. Typ. Max. 5 .5 13.2 26.4 52.8 0.3 Units ● 2W Ou tput Power ● Miniature SIP .
Manufacture

MicroPower Direct

Datasheet
Download D221 Datasheet




 D221
D200 Series
Single & Dual Output
Miniature, 2W SIP
DC/DC Converters
Key Features:
2W Output Power
Miniature SIP Case
Single & Dual Outputs
1,000 VDC Isolation
>2 MHour MTBF
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
5 VDC Input 4.5 5.0 5.5
Input Voltage Range
12 VDC Input 10.8 12.0 13.2
24 VDC Input 21.6 24.0 26.4
VDC
48 VDC Input 43.2 48.0 52.8
Input Filter
Internal Capacitor
Reverse Polarity Input Current
0.3 A
28 Standard Models
Output
Industry Standard Pin-Out Parameter
Output Voltage Accuracy
Conditions
Min. Typ. Max.
±1.0 ±3.0
Units
%
Output Voltage Balance
Dual Output , Balanced Loads
±1.0 %
Line Regulation
For Vin Change of 1%
±1.2
%
Load Regulation
See Model Selection Guide
Ripple & Noise (20 MHz)
75 mV P - P
Output Power Protection
120 %
Temperature Coefficient
±0.02 %/ºC
Output Short Circuit
Momentary (0.5 Sec.)
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,000
VDC
Isolation Resistance
500 VDC 1,000
Isolation Capacitance
100 kHz, 1V
60
pF
Switching Frequency
125 kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
ºC
Operating Temperature Range
Case
+100
ºC
Storage Temperature Range
-40
+125
ºC
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95 %
Physical
MicroPower Direct
232 Tosca Drive
Stoughton, MA 02072
USA
T: (781) 344-8226
F: (781) 344-8481
E: sales@micropowerdirect.com
W: www.micropowerdirect.com
Case Size (5V, 12V & 24V Input Models)
Case Size (48V Input Models)
Case Material
Weight
Reliability Specifications
Parameter
MTBF
Absolute Maximum Ratings
0.76 x 0.24 x 0.37 Inches (19.5 x 6.0 x 9.5 mm)
0.76 x 0.28 x 0.37 Inches (19.5 x 7.2 x 9.5 mm)
Non-Conductive Black Plastic (UL94-V0)
0.09 Oz (2.7g)
Conditions
Min. Typ. Max.
MIL HDBK 217F, 25ºC, Gnd Benign 2.0
Units
MHours
Parameter
Conditions
Min. Typ. Max. Units
5 VDC Input -0.7
9.0
Input Voltage Surge (1 Sec)
12 VDC Input -0.7
24 VDC Input -0.7
18.0
VDC
30.0
48 VDC Input -0.7
55.0
Lead Temperature
1.5 mm From Case For 10 Sec
260 ºC
Internal Power Dissipation
All Models
650 mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.




 D221
Model Selection Guide
Model
Number
D201
D202
D203
D204
D205
D206
D207
D211
D212
D213
D214
D215
D216
D217
D221
D222
D223
D224
D225
D226
D227
D231
D232
D233
D234
D235
D236
D237
Input
Voltage (VDC)
Current (mA)
Nominal Range Full-Load No-Load
5
4.5 - 5.5
533
35
5
4.5 - 5.5
513
35
5
4.5 - 5.5
495
35
5
4.5 - 5.5
499
35
5
4.5 - 5.5
533
35
5
4.5 - 5.5
504
35
5
4.5 - 5.5
501
35
12 10.8 - 13.2 204
25
12 10.8 - 13.2 212
25
12 10.8 - 13.2 196
25
12 10.8 - 13.2 200
25
12 10.8 - 13.2 216
25
12 10.8 - 13.2 201
25
12 10.8 - 13.2 200
25
24 21.6 - 26.4 92
10
24 21.6 - 26.4 108
10
24 21.6 - 26.4 101
10
24 21.6 - 26.4 101
10
24 21.6 - 26.4 108
10
24 21.6 - 26.4 102
10
24 21.6 - 26.4 99
10
48 43.2 - 52.8 59
10
48 43.2 - 52.8 54
10
48 43.2 - 52.8 51
10
48 43.2 - 52.8 50
10
48 43.2 - 52.8 54
10
48 43.2 - 52.8 51
10
48 43.2 - 52.8 50
10
Voltage
(VDC)
3.3
5.0
12.0
15.0
±5.0
±12.0
±15.0
3.3
5.0
12.0
15.0
±5.0
±12.0
±15.0
3.3
5.0
12.0
15.0
±5.0
±12.0
±15.0
3.3
5.0
12.0
15.0
±5.0
±12.0
±15.0
Output
Current
(mA, Max)
400.0
400.0
165.0
133.0
±200.0
±83.0
±66.0
400.0
400.0
165.0
133.0
±200.0
±83.0
±66.0
400.0
400.0
165.0
133.0
±200.0
±83.0
±66.0
400.0
400.0
165.0
133.0
±200.0
±83.0
±66.0
Current
(mA, Min)
10.0
8.0
3.0
2.5
±4.0
±1.5
±1.0
10.0
8.0
3.0
2.5
±4.0
±1.5
±1.0
10.0
8.0
3.0
2.5
±4.0
±1.5
±1.0
10.0
8.0
3.0
2.5
±4.0
±1.5
±1.0
Load
Regulation
(%, Max)
12
12
8
8
12
8
8
8
8
8
8
8
8
8
8
8
8
8
8
8
8
8
8
8
8
8
8
8
Efficiency
(%, Typ)
Fuse Rating
Slow-Blow
(mA)
75 1,000
78 1,000
80 1,000
80 1,000
75 1,000
79 1,000
79 1,000
67 500
78 500
85 500
83 500
77 500
82 500
82 500
74 200
77 200
81 200
82 200
77 200
81 200
84 200
70 100
77 100
81 100
82 100
76 100
81 100
82 100
Notes:
1. Output load regulation is specified for a load change of 20% to 100%.
2. When measuring output ripple, it is recommended that an external ceramic capacitor (approx 10 µF)
be placed from the +Vout pin to the -Vout pin for single output units and from each output to common
for dual output units.
3. All 3.3, 5 and ±5 VDC output models may be operated to +85ºC ambient with an unobstructed airflow
of 3.6 ft/S (1.1 m/S).
4. The 5V, 12V and 24V input units do not require external components to operate, but the use of an
input capacitor (10 µF) may enhance performance in some applications. An output capacitor (1.0 µF
to 10 µF) may be used to reduce ripple. The 48V input models require an input capacitor of 4.7 uF to
47 uF (dependent upon the application).
5. Dual output units may be connected to provide a 10V, 24V or 30 VDC output. To do this, connect the
load across the positive (+Vout) and negative (-Vout) outputs and float the output common.
6. It is recommended that a fuse be used on the input of a power supply for protection. See the table above
for the correct rating.
Pin Connections
Pin Single
Dual
1 +Vin +Vin
2 -Vin -Vin
4 -Vout -Vout
5 No Pin Common
6 +Vout +Vout
Mechanical Dimensions
Derating Curve
Capacitive
Load
Single Output
(μF Max)
470
Dual Output
(μF Max)
±390
Notes: All dimensions are typical in inches (mm)
Tolerance x.xx = ±0.01 (±0.25)
Pin 1 is marked by a “dot” or indentation on the
MicroPower Direct side of the unit
For 5V, 12V & 24V input models, “W” = 0.24 in
(6.0 mm)
www.micropowerdirect.com
For 48V input models, “W” = 0.28 in (7.2 mm)
232 Tosca Drive Stoughton, MA 02072
TEL: (781) 344-8226 FAX: (781) 344-8481 E-Mail: sales@micropowerdirect.com







Recommended third-party D221 Datasheet






@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site (Privacy Policy & Contact)