MBRS230LT3 Surface Mount Schottky Power Rectifier
SMB Power Surface Mount Package
. . . employing the Schottky Barrier p...
MBRS230LT3 Surface Mount
Schottky Power Rectifier
SMB Power Surface Mount Package
. . . employing the
Schottky Barrier principle in a metal-to-silicon power rectifier. Features epitaxial construction with oxide passivation and metal overlay contact. Ideally suited for low voltage, high frequency switching power supplies; free wheeling diodes and polarity protection diodes.
http://onsemi.com
Compact Package with J-Bend Leads Ideal for Automated Handling Highly Stable Oxide Passivated Junction Guardring for Over-Voltage Protection Low Forward Voltage Drop Case: Molded Epoxy Epoxy Meets UL94, VO at 1/8″ Weight: 95 mg (approximately) Finish: All External Surfaces Corrosion Resistant and Terminal Leads are Readily Solderable Maximum Temperature of 260°C/10 Seconds for Soldering Available in 12 mm Tape, 2500 Units per 13″ Reel, Add “T3” Suffix to Part Number Cathode Polarity Band Marking: 2BL3
SCHOTTKY BARRIER RECTIFIER 2.0 AMPERES 30 VOLTS
Mechanical Characteristics:
SMB CASE 403A PLASTIC
MARKING DIAGRAM
YWW 2BL3
MAXIMUM RATINGS
Rating Peak Repetitive Reverse Voltage Working Peak Reverse Voltage DC Blocking Voltage Average Rectified Forward Current (At Rated VR, TC = 110°C) Peak Repetitive Forward Current (At Rated VR, Square Wave, 20 kHz, TC = 105°C) Non-Repetitive Peak Surge Current (Surge Applied at Rated Load Conditions, Halfwave, Single Phase, 60 Hz) Storage/Operating Case Temperature Operating Junction Temperature Voltage Rate of Change (Rated ...