KV-29FX66

AE-6B SELF DIAGNOSTIC SOFTWARE The identification of errors within the AE-6B chassis is triggered in one of two ways :- 1: Busy or 2: Device failure to respond to IIC. In the event of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with a continuous flashing LED) and then communicate with each device in turn to establish if a device is faulty. If a device is found to be faulty the relevant device number will be displayed through the LED (Series of flashes which must be counted) See table 1., non fatal errors are reported using this method. Each time the software detects an error it is stored within the NVM. See Table 2. Table 1 How to enter into Table 2 LED Code 00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 Error Message No error Reser ved OCP ( Over Current Protection ) Over Voltage Protection No Ver tical Sync IKR Error at power on IIC bus clock and/or data lines low at power on NVM no IIC bus acknowledge at power on Horizontal Protection Tuner no acknowledge at power on Sound Processor Error Reser ved Scanrate Error DAC Error Backend Error Dynamic Convergence Error PIP Error 1. 2. 2. 3. Turn on the main power switch of the TV set. Program Remote Commander for Operation in Service Mode. [See Page 20]. Press ‘VIDEO’ ‘VIDEO’ > ‘MENU’ > ERROR MENU on the Remote Commander. The following table will be displayed indicating the error count. Table 2 ERROR MENU E02 E03 E04 E05 E06 E07 E08 E09 E10 E11 E12...