Coaxial Transceiver Interface
MYSON TECHNOLOGY
Coaxial Transceiver Interface
FEATURES
• • • • • • • • • • Compatible with IEEE 802.3 10Base5 (Ethernet...
Description
MYSON TECHNOLOGY
Coaxial Transceiver Interface
FEATURES
Compatible with IEEE 802.3 10Base5 (Ethernet) and 10Base2 (Cheapernet). Internal AUI squelch circuitry for noise rejection. Transmission IDL detection at end of packet and dribble bit rejection window. Reception dribble bit rejection window. Reception and transmission mode collision detection. Extended collision detection to turn off receiving path. CD heartbeat externally controllable. Advanced low-power, high-performance CMOS technology. ESD protection greater than 2000 Volts. 16-pin PDIP and 28-pin PLCC packages.
MTD492
GENERAL DESCRIPTION
The MTD492 transceiver integrates the coaxial cable interface functions of the Medium Attachment Unit (MAU) in Ethernet or Cheapernet LAN applications. In an Ethernet 10Base5 network, MTD492 is mounted on the thick Ethernet coaxial cable and connects to a station through an AUI cable. For Cheapernet applications, MTD492 is connected to the Cheapernet coaxial cable through a BNC connector and is usually mounted on the LAN adapter in a station.
BLOCK DIAGRAM
COAX HIGH PASS EQUALIZATION FXI GND LOW PASS FILTER LOW PASS FILTER + CARRIER SENSE
COM
AUI DRIVER
RX+ RXAUI DRIVER CD+ CDTX+ TX-
125 10K
XMT CDS LOW PASS FILTER + WAVEFORM SHAPING 10MHz CLK OSC WATCH DOG TIMER 26ms COLLISION
VEE
RECV TXO
+ -
DC/AC SQUELCH
VEE RR+
1K
JABBER RESET X M T S Q TIMER 0.4sec
REFERENCE CIRCUIT
RR-
TRANSMIT STATE MACHINE HBE
RECEIVE STATE MACHINE
This datasheet contai...
Similar Datasheet