ALN0925

m o c . Features UDescription 4 t e e h S a at .D w w w · 37.5 dB Gain at 925 MHz · 19 dBm P1dB · 35 dBm Output IP3 TM PlerowTM ALN0925 Low Noise Amplifier · 1.1 dB Noise Figure · Operating at Single 5 V Supply · 80 mA Current Consumption Specifications Parameter Frequency Range Gain Gain Flatness Noise Figure Output IP3 S11 / S22 Output P1dB Supply Current Supply Voltage Impedance Max. RF Input Power @ CDMA 20FA Package Type & Size 1) Measurement conditions are as follows: T = 25°C, VCC = 5 V, Freq. = 925 MHz, 50 ohm system. 2) OIP3 is measured with two tones at an output power of 10 dBm / tone separated by 1 MHz. 3) Note: We recommend that the VSWR toward a source and load be less than 1:4 to avoid an unwanted oscillation. Outline Drawing ALN plerow ASB Inc. TOP m o .c U 4 t e e h S a t a .D w w w Unit Specification 890 ~ 960 37.5 1.1 35 ± 0.5 MHz dB dB dB dBm dB -14 / -14 19 5 80 dBm mA V Ω 50 5 dBm mm SMT, 13Wx13Lx3.8H Pin Number 3 8 10 The plerow ALN-series is the compactly designed surface-mount module for the use of the LNA with or without the following gain blocks in the infrastructure equipment of the mobile wirelss (CDMA, GSM, PCS, PHS, WCDMA, DMB, WLAN, WiBro, WiMAX), GPS, satellite communication terminals and so on. It has an exceptional performance of low noise figure, high gain, high OIP3, and low bias current. The stability factor is always kept less than unity over the application band in order to confirm its unconditionally stable implementation...