MINISMDM110

( DataSheet : www.DataSheet4U.com ) Tyco / Electronics Raychem Circuit Protection 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 Fax: 800-227-4866 PolySwitch® PTC Devices Overcurrent Protection Device PRODUCT: miniSMDM110 DOCUMENT: SCD 24315 PCN: 893407 REV LETTER: C REV DATE: MARCH 27, 2002 PAGE NO.: 1 OF 1 Specification Status: Released Maximum Electrical Rating Voltage: 8 VDC Current: 40A Notes: 1. All terminations are gold plated. Partial coverage of plating with solder may occur without effect on solderability or electrical performance 2. Devices cannot be wave soldered. 3. Drawing not to scale Marking: Manufacturer’s Mark 110 Part Identification Lot Identification TABLE I. DIMENSIONS: A MIN mm: in:* 4.35 (0.172) MAX 4.75 (0.187) MIN 1.75 (0.069) B MIN 2.00 (0.079) MAX 3.05 (0.120) C MAX 3.60 (0.142) MIN 1.4 (0.055) D MIN 1.7 (0.067) *Rounded off approximation TABLE II. PERFORMANCE RATINGS: CURRENT RATINGS ** TIME TO TRIP ** SECONDS AT 25°C, 8.0A MAX 0.3 RESISTANCE TRIPPED-STATE VALUES POWER DISSIPATION** OHMS WATTS AT AT 25°C 25°C, 8.0V MIN MAX* MAX 0.060 0.180 0.6 AMPERES AMPERES AMPERES AT 0°C AT 25°C AT 60°C HOLD TRIP HOLD TRIP HOLD TRIP 1.2 2.1 1.1 2.0 0.77 1.4 *Maximum resistance is measured 1 hour after reflow. ** Values specified were determined using PCB’s with 0.030”X1.5 ounce copper traces. Reference Documents: Precedence: Effectivity: CAUTION: PS300 This specification takes precedence over documents referenced herein. Refer...