Disk Drive
DK225A-14 Specifications
www.DataSheet4U.com
Page 1 of 2
DK225A-14 2.5-inch Disk Drive Specifications & Jumper Setting...
Description
DK225A-14 Specifications
www.DataSheet4U.com
Page 1 of 2
DK225A-14 2.5-inch Disk Drive Specifications & Jumper Settings
MODEL INTERFACE FORMATTED CAPACITY
DK225A-14 ATA-3 1.44 Gbytes
PARAMETERS
CYLINDERS HEADS BYTES PER SECTOR SECTORS PER TRACK ROTATIONAL SPEED AVERAGE LATENCY 4188 16 512 63 4,464 rpm 7 ms
TRANSFER RATE
INTERNAL (Disk-Buffer) BUFFER-HOST (Host-Buffer) BUFER SIZE 5.7~9.0 Mbytes/ sec 16.6 MB/s max. (PIO Mode4, DMA Mode2) 128 Kbytes
SEEK TIMES
AVERAGE MAXIMUM MINIMUM 12 ms 24 ms 3 ms
PHYSICAL SPECIFICATIONS
HEIGHT WIDTH DEPTH WEIGHT 12.7. mm (0.49in.) 70. mm (2.75in.) 100.0 mm (3.94in.) Approx. 155g (5.11 oz.)
POWER REQUIREMENTS +5V ± 5%
SEEK MAXIMUM 0.65A 9A
MASTER/SLAVE JUMPER SETTINGS (" " marked pins are removed for key) MASTER/ SINGLE: SLAVE: NO JUMPERS REQUIRED JUMPER A-B
w
w
w
.D
at
TYPICAL INSTALLATION:
1. Setup drive parameters in system bios (refer to above parameter table)
h S a
t e e
4U
.
m o c
http://www.hitachi.com/storage/products/hdd/oldspecs/dk225a14.html
10/8/2001
DK225A-14 Specifications
www.DataSheet4U.com
Page 2 of 2
Note: If system asks for write Pre-comp and Landing Zone values, use the system default values. 2. Create DOS partition- type "FDISK" to create logical capacity (refer to your operating system manual for details). 3. Format with DOS system- type "Format C:/S" to complete installation
IDE DRIVE Interface Pin Assignments:
© The statements in this publication are not intended to create any warranty, expres...
Similar Datasheet