Specification
www.DataSheet4U.com
SPECIFICATION FSP250-60SV
w
w
w
a D .
S a t
e e h
U 4 t
m o .c
Page1
www.DataSheet4U.com
...
Description
www.DataSheet4U.com
SPECIFICATION FSP250-60SV
w
w
w
a D .
S a t
e e h
U 4 t
m o .c
Page1
www.DataSheet4U.com
1.0
GENERAL REQUIREMENTS
This specification describes a 250 watts power supply. With+ 5V stand-by , remote ON/OFF control for ATX system
2.0
INPUT REQUIREMENTS
The power supply shall operate at 115Vrms ±10% or 230Vrms ±10%. The power supply shall operate from an AC mains frequency of 47 through 63 Hz. The Ac mains single-cycle peak inrush current shall be limited to 70 amps cold,90 amps warm measured at 230 Vrms, 50 Hz and coinciding with the AC main voltage peak. The AC mains steady-state RMS input current shall be: 6.0 amps maximum / 115 Vrms, 60 Hz. 3.0 amps maximum / 230 Vrms, 50 Hz.
3.0
OUTPUT REQUIREMENTS 3.1 OUTPUT VOLTAGE AND CURRENT
MINIMUM NORMAL MAXIMUM LOAD LOAD LOAD +3.3V +5V +12V -12V *-5V +5Vsb 0.3A 1.5A 0.5A 0.0A 0.0A 0.0A 7A 10.4A 3.44A 0.25A 0.15A 1.0A 7.58/14A 25/20.76A 13A 0.8A 0.3A 2.0A LOAD REG. ±5% ±5% ±5% ±10% ±10% ±5% LINE REG. ±1% ±1% ±1% ±2% ±2% ±1% RIPPLE & NOISE 50mV P-P 50mV P-P 120mV P-P 120mV P-P 120mV P-P 50mV P-P
w
w
w
.D
at
h S a
*-5V 0ptional (1)+3.3V &+5V total output not exceed 150 W. When +3.3V is load to 14A,the +5V maximum load is 20.76A. When +3.3V is load to 7.58A,the +5V maximum load is 25A. (2) +3.3V & +5V & +12V total output not exceed 232.5W. (3)All outputs shall be safety-isolated from the AC mains and share a common return. This common return must be connected to supply chassis. (4)Voltages and ri...
Similar Datasheet