DABIC-5 8-Channel Source Driver
UDN2987x-6
DABIC-5 8-Channel Source Driver with Overcurrent Protection
Features and Benefits
▪ 4.75 to 35 V driver supp...
Description
UDN2987x-6
DABIC-5 8-Channel Source Driver with Overcurrent Protection
Features and Benefits
▪ 4.75 to 35 V driver supply voltage ▪ Output enable-disable (OE/R) ▪ 350 mA output source current ▪ Overcurrent protected ▪ Internal ground clamp diodes ▪ Output Breakdown Voltage 35 V minimum ▪ TTL, DTL, PMOS, or CMOS compatible inputs ▪ Internal Thermal Shutdown (TSD)
Package: 20-pin SOICW (suffix LW)
Not to scale
Description
Providing overcurrent protection for each of its eight sourcing outputs, the UDN2987LW-6 driver is used as an interface between standard low-level logic and relays, motors, solenoids, LEDs, and incandescent lamps. This device includes thermal shutdown and output transient protection/clamp diodes for use with sustaining voltages to 35 V.
In this driver, each channel includes a latch to turn off that channel if the maximum channel current is exceeded. All channels are disabled if the thermal shutdown is activated. A common FAULT output is used to indicate either chip thermal shutdown or any overcurrent condition.All outputs are enabled by pulling the common OE/R input high. When OE/¯R is low, all outputs are inhibited and the eight latches are reset. The OE/¯R function can be especially important during power-up, in preventing floating inputs from turning on the outputs.
Under normal operating conditions, each of eight outputs will source in excess of 100 mA continuously at an ambient temperature of 25°C and a supply of 35 V. The overcurrent fault circuit will...
Similar Datasheet