Powerful Energy Meter Chipset
Supports IEC 60687/61036 and ANSI C12.1/12.20
Suitable for class0.5 and class0.2 meter
Full four quadrant measurement of parameters
SPI® compatible serial interface
Pulse output with programmable pulse constant as
pulses/kWh or Wh/pulse
Programmable duty cycle for pulse output
chipset can be interfaced to any general-purpose microproces-
sor to develop state of the art tri-vector or polyphase energy
metering solutions with a wide range of basic currents from 1 A
to 30 A. By incorporating a comprehensive data set of parame-
ters, including instantaneous measurements, accumulated
parameters, and harmonic analysis data, the ADSST-SALEM-3T
chipset meets high end energy metering requirements. The abil-
ity to easily configure the chipset for various parameters makes
it a very flexible solution.
Embedded calibration routines for gain and dc offset
The phase and nonlinearity compensation for current
Software based phase and nonlinearity compensation for
15 kHz sampling frequency
UART mode enables a PC to directly access all computed
Flags to indicate tamper conditions
Single 3.0 V supply
transformers is done in software (patent pending) without
having to use any passive components in the circuit for
compensation, thus minimizing variations in accuracy with
temperature and time.
The ADSST-SALEM-3T measures and computes a large num-
ber of parameters essential for high end metering.
Developer’s kit to accelerate design process (See
Ordering Guide for separate ordering number.)
The ADSST-SALEM-3T energy meter chipset consists of an
efficient ADSST-218x digital signal processor (DSP), a fast and
accurate 6-channel, 16-bit ADSST-73360LAR sigma-delta ana-
log-to-digital converter (ADC), and metering software. Two
chipset versions are available to support differing ranges of
operating temperature: The ADSST-EM-3040 chipset is rated at
0°C to 70°C for commercial applications, while the ADSST-EM-
Inductive Reactive Power
Capacitive Reactive Power
3041 chipset operates at –25°C to +85°C for industrial use.
Positive Active Energy
Negative Active Energy
Each Phase TotalDataShee
Positive Inductive Reactive Energy
Negative Inductive Reactive Energy
Positive Capacitive Reactive Energy
Negative Capacitive Reactive Energy
Voltage Magnitude and Phase for All
Odd Harmonics up to 21st Order
Current Magnitude and Phase for All
Odd Harmonics up to 21st Order
Figure 1. Block Diagram of a Functional Meter
The ADC and DSP are interfaced to simultaneously acquire
voltage and current samples on all three phases and to perform
mathematically intensive computations to calculate various
instantaneous parameters and perform harmonic analysis. The
The ADSST-SALEM-3T offers some excellent features that
make the final meter cost-effective and easy to manufacture.
Information furnished by Analog Devices is believed to be accurate and reliable.
However, no responsibility is assumed by Analog Devices for its use, nor for any
DataSheet4Uinf.rcinogemments of patents or other rights of third parties that may result from its use.
Specifications subject to change without notice. No license is granted by implication
or otherwise under any patent or patent rights of Analog Devices. Trademarks and
registered trademarks are the property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Fax: 781.326.8703 © 2004 Analog Devices, Inc. All rights reserved.
DataSheet4 U .com