SUBMINIATURE CONTROLLER
www.DataSheet4U.com
hytek
Microsystems
FEATURES: > PROPORTIONAL CONTROL > SMALL SIZE > DRIVE CURRENT TO +/- 2 AMPS > OP...
Description
www.DataSheet4U.com
hytek
Microsystems
FEATURES: > PROPORTIONAL CONTROL > SMALL SIZE > DRIVE CURRENT TO +/- 2 AMPS > OPERATION TO 12 VOLTS > CONTROL ABOVE/BELOW AMBIENT
HY-5610 TEC CONTROLLER
11/97
SUBMINIATURE CONTROLLER FOR THERMOELECTRIC COOLERS
ACTUAL SIZE
DESCRIPTION:
The HY-5610 is a subminiature proportional temperature controller for thermoelectric coolers (TEC). This device is intended for “heat or cool” fixed temperature applications where front panel controls and digital readouts are not required. The HY-5610 uses a thermistor bridge to precisely measure and regulate the temperature of a device affixed to a TEC. With proper heat sinking the power stage of this device will deliver up to +/- 2 Amperes of current to a TEC and will operate from a 5 to 12 Volt power supply.
FIGURE 1 RCH
MAXIMUM RATINGS:
Rating Supply Voltage 1 (Voltage on Pin 8) Supply Voltage 2 (Voltage on Pin 10) Current Sink (Heat and Cool Cycle) Maximum Power Dissipation Operating Temperature (Case) Storage Temperature Symbol VDD VS IS PMAX TMAX TSTG Value +20 +12 2.5 6 120 -65 to +150 Unit Volts DC Volts DC Amperes Watts °C °C
SIMPLIFIED SCHEMATIC OF THE HY-5610 SHOWN WITHIN THE DASHED LINES
RCH RCC
THIS IS THE CURRENT LIMIT RESISTOR FOR THE HEAT CYCLE. THIS IS THE CURRENT LIMIT RESISTOR FOR THE COOLING CYCLE.
THERMISTOR
RT
RCC
SIGNAL COMMON PIN N0. 1 7 6 5 3 9
-
+
VS
+
VDD
+
RS
RG
RL CL
THERMOELECTRIC COOLER
PWR. GND 13 2 10 11 12 8
1 V/I 20
1 V/I 20
+5V +2.5V
10 MΩ
+1.25...
Similar Datasheet