OP268FPS

www.DataSheet4U.com Product Bulletin OP268FPS November 2000 Plastic Point Source Infrared Emitting Diode Type OP268FPS Features Point source irradiance pattern Flat lensed for wide radiation angle Easily stackable on 0.100”(2.54 mm) hole centers Absolute Maximum Ratings (TA = 25o C unless otherwise noted) Reverse Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.0 V Continuous Forward Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 mA Peak Forward Current (2 µs pulse width, 0.1% duty cycle). . . . . . . . . . . . . . . . . . 1.0 A Storage and Operating Temperature Range . . . . . . . . . . . . . . . . . . . -40°C to +100°C Lead Soldering Temperature [1/16 inch (1.6 mm) from case for 5 sec. with soldering iron] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260°C (1) Power Dissipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 mW(2) NOTES: (1) RMA flux is recommended. Duration can be ex tended to 10 seconds maximum when flow soldering. Max imum 20 grams force may be applied to the leads when soldering. (2) Derate linearly 1.33 mW/°C above 25 °C. (3) E e(APT) is a measurement of the average apertured radiant en ergy incident upon a sensing area 0.081” (2.06 mm) in diameter, perpendicular to and centered on the mechanical axis of the “ emitting surface”a...