EEPROM Programmable 3-PLL Clock Generator
www.DataSheet4U.com
FS6370-01
EEPROM Programmable 3-PLL Clock Generator IC
1.0
• • • • • • • • • •
2
Features
Just-in...
Description
www.DataSheet4U.com
FS6370-01
EEPROM Programmable 3-PLL Clock Generator IC
1.0
2
Features
Just-in-time customization of clock frequencies via internal non-volatile 128-bit serial EEPROM I Cä-bus serial interface Three on-chip PLLs with programmable Reference and Feedback Dividers Four independently programmable muxes and post dividers Programmable power-down of all PLLs and output clock drivers Tristate outputs for board testing One PLL and two mux/post-divider combinations can be modified via SEL_CD input 5V to 3.3V operation Accepts 5MHz to 27MHz crystal resonators ROM-based device available for cost reduction migration path – contact your AMI sales representative for more information
2.0
Description
The FS6370 is a CMOS clock generator IC designed to minimize cost and component count in a variety of electronic systems. Three EEPROM-programmable phaselocked loops (PLLs) driving four programmable muxes and post dividers provide a high degree of flexibility. An internal EEPROM permits just-in-time factory programming of devices for end user requirements.
Figure 1: Pin Configuration
VSS SEL_CD PD/SCL VSS XIN XOUT OE/SDA VDD
1 2 3 16 15 14
VDD CLK_A VDD CLK_B CLK_C VSS CLK_D MODE
FS6370
4 5 6 7 8
13 12 11 10 9
16-pin (0.150”) SOIC
Figure 2: Block Diagram
XIN XOUT Reference Oscillator PLL A
Mux A
Post Divider A
CLK_A
MODE PD/SCL
Power Down Control PLL B I2C-bus Interface
Mux B
Post Divider B
CLK_B
OE/SDA PLL C EEPROM Mux C Post Divider C...
Similar Datasheet