T1/CEPT/ISDN Test Transformer
www.DataSheet4U.com
T1/CEPT/ISDN
TEW5009 is specifically designed to be used as an isolation transformer in test setups...
Description
www.DataSheet4U.com
T1/CEPT/ISDN
TEW5009 is specifically designed to be used as an isolation transformer in test setups for testing Longitudinal Balance and Return Loss in Primary Rate and Basic Rate Circuits. Special attention has been given to the problems associated with the coupling capacitance between windings when
Test Transformer
TEW5009
transforming from balanced to unbalanced circuits. Shield between windings. Very low Leakage Inductance. Excellent balance.
MECHANICAL
2
H
4 Unbal. 9 5
ALL DIMENSIONS ARE IN INCHES
0.15
7 Bal. 3 8
DIA 0.025
0.020 8 PLACES
DRILL PATTERN COMPONENT SIDE 2 HOLES DIA. 0.055" 10 HOLES DIA. 0.040"
6
10 G
W
G
0.70
Dimensions L 1.15" max. 1.00" max. 0.85" max
GRID 0 .10" X 0.10"
5 1
1 5
DOT AT PIN1 L G. 2 GND PINS 0.020" X 0.040"
W H
ELECTRICAL SPECIFICATIONS
TEW5009 100 Ω Bal. 100 Ω Unbal. < 1.0 dB Range, 75 - 150 Ω “ ” 1 KHz - 10 Mhz
Impedance
TEW5009
Pri. Sec.
(2-7)+(3-8) (4-9)
Frequency Response Turns ratio Inductance Leakage Ind. Wind. Res. Dielectric Strength Pri. Sec. (2-7)+(3-8) (4-9) (2-7):(3-8):(4-9) (4-9)
93/04/26
1:1:2 > 20 mH < 2.0 µH 1.92 Ω 0.97 Ω 1500 Vrms
ISSUE: B
Filtran Limited
229 Colonnade Road, Nepean, Ontario, Canada. K2E 7K3, Tel: (613) 226-1626 Fax: (613) 226-7124
6-3
T1/CEPT/ISDN
Test Transformer
TEW5009
R DEVICE UNDER TEST
R
Test Transformer
TEW5009
Figure 1: Test circuit for Longitudinal Balance.
R
R
R
R
Device under test
R
TEW5009
Figure 2: Test circuit for Retu...
Similar Datasheet