CMOS Photoelectric Smoke Detector ASIC
www.DataSheet4U.com
R&E International
RE46C145
CMOS Photoelectric Smoke Detector ASIC with Interconnect and Timer Mode ...
Description
www.DataSheet4U.com
R&E International
RE46C145
CMOS Photoelectric Smoke Detector ASIC with Interconnect and Timer Mode Product Specification
General Description
The RE46C145 is low power CMOS photoelectric type smoke detector IC. With minimal external components this circuit will provide all the required features for a photoelectric type smoke detector. The design incorporates a gain selectable photo amplifier for use with an infrared emitter/detector pair. An internal oscillator strobes power to the smoke detection circuitry for 100us every 10 seconds to keep standby current to a minimum. If smoke is sensed the detection rate is increased to verify an alarm condition. A high gain mode is available for push button chamber testing. In the diagnostic mode the photo amplifier output is available on pin 15 for production calibration of the photo chamber. A check for a low battery condition and chamber integrity is performed every 43 seconds when in standby. The temporal horn pattern supports the NFPA 72 emergency evacuation signal. An interconnect pin allows multiple detectors to be connected such that when one units alarms, all units will sound. An internal 10 minute timer can be used for a reduced sensitivity mode. Utilizing low power CMOS technology the RE46C145 was designed for use in smoke detectors that comply with Underwriters Laboratory Specification UL217 and UL268.
Features
Internal Power On Reset Low Quiescent Current Consumption Available in 1...
Similar Datasheet