STLVDS385

www.DataSheet4U.com STLVDS385 +3.3V PROGRAMMABLE LVDS TRANSMITTER 24-BIT FLAT PANEL DISPLAY (FPD) LINK-85MHZ s s s s s s s s s s s 20 TO 85 MHz SHIFT CLOCK SUPPORT BEST–IN–CLASS SET & HOLD TIMES ON TxINPUTs Tx POWER CONSUMPTION <130 mW (typ) @85MHz GRAYSCALE Tx POWER-DOWN MODE <200µW (max) SUPPORTS VGA, SVGA, XGA aND SINGLE/ DUAL PIXEL SXGA. NARROW BUS REDUCES CABLE SIZE AND COST UP TO 2.38 Gbps THROUGHPUT UP TO 297.5 Megabytes/sec BANDWIDTH 345 mV (typ) SWING LVDS DEVICES FOR LOW EMI PLL REQUIRES NO EXTERNAL COMPONENTS COMPATIBLE WITH TIA/EIA -644 LVDS STANDARD TSSOP56 DESCRIPTION The STLVDS385 transmitter converts 28 bits of LVCMOS/LVTTL data into four LVDS (Low Voltage Differential Signaling) data streams. A phase-locked transmit clock is transmitted in parallel with the data streams over a fifth LVDS ORDERING CODES Type STLVDS385BTR Temperature Range -10 to 70°C link. Every cycle of the transmit clock 28 bits of input data are sampled and transmitted. At a transmit clock frequency of 85 MHz, 24 bits of RGB data and 3 bits of LCD timing and control data (FPLINE, FPFRAME, DRDY) are transmitted at a rate of 595 Mbps per LVDS data channel. Using a 85 MHz clock, the data throughput is 297.5 Mbytes/sec. The transmitter can be programmed for Rising edge strobe or Falling edge strobe through a dedicated pin. A Rising edge or Falling edge strobe transmitter will inter operate with a Falling edge strobe Receiver without any translation logic. Package TSSOP56 (Tape & Ree...