www.DataSheet4U.com
CS8161 12 V, 5.0 V Low Dropout Dual Regulator with ENABLE
The CS8161 is a 12 V/5.0 V dual output li...
www.DataSheet4U.com
CS8161 12 V, 5.0 V Low Dropout Dual
Regulator with ENABLE
The CS8161 is a 12 V/5.0 V dual output linear
regulator. The 12 V ±5.0% output sources 400 mA and the 5.0 V ±2.0% output sources 200 mA. The on board ENABLE function controls the
regulator’s two outputs. When the ENABLE pin is low, the
regulator is placed in SLEEP mode. Both outputs are disabled and the
regulator draws only 200 nA of quiescent current. The primary output, VOUT1 is protected against overvoltage conditions. Both outputs are protected against short circuit and thermal runaway conditions. The CS8161 is packaged in a 5 lead TO−220 with copper tab. The copper tab can be connected to a heat sink if necessary.
Features http://onsemi.com
TO−220 FIVE LEAD T SUFFIX CASE 314D 1 5 TO−220 FIVE LEAD TVA SUFFIX CASE 314K
Two Regulated Outputs − 12 V ±5.0%; 400 mA − 5.0 V ±2.0%; 200 mA Very Low SLEEP Mode Current Drain 200 nA Fault Protection − Reverse Battery (−15 V) − 74 V Load Dump − −100 V Reverse Transient − Short Circuit − Thermal Shutdown Pb−Free Packages are Available*
1
1
TO−220 FIVE LEAD THA SUFFIX CASE 314A 5
PIN CONNECTIONS
Tab = GND Pin 1. VIN 2. VOUT1 3. GND 4. ENABLE 5. VOUT2 1
DEVICE MARKING INFORMATION
See general marking information in the device marking section on page 9 of this data sheet.
ORDERING INFORMATION
See detailed ordering and shipping information in the package dimensions section on page 9 of this data sheet.
*For additional information on our Pb−Free...