HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER
Features
AH287
HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER
General Description
• On Chip Hall Sensor • Rotor-L...
Description
Features
AH287
HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER
General Description
On Chip Hall Sensor Rotor-Locked Shutdown Automatically Restart Built-in Zener Protection for Output Driver Operating Voltage: 3.8V~28V Output Current: IO(AVE) = 400mA Lead Free Packages: SIP-4L and SOT89-5L (Note 1) SIP-4L and SOT89-5L: Available in “Green” Molding
Compound (No Br, Sb) Lead Free Finish/ RoHS Compliant (Note 2)
AH287 is a monolithic fan motor controller with Hall sensor’s capability. It contains two complementary open-drain drivers for motor’s coil driving, automatic lock shutdown and restart function relatively.
Rotor-lock shutdown detection circuit turns off the output driver when the rotor is blocked to avoid coil overheat. Then, the automatic recovery circuit will restart the motor. These protected actions are repeated and periodic during the blocked period. Until the blocking is removed, the motor recovers and runs normally.
Typical Application Circuit
24V D2
287
D1 12 34 GND
D3 C1 DO
DOB
L2 L1
48V 48V
Note: The optional Capacitor C1 and Diode D3 are for power stabilization. C1 is recommended to be E-Cap., luF/25V; D3 is recommended to be Zener Diode, VZ =27V. Which C1and D3 value need to be fine tuned to optimize design for different coils and power suppliers.
24V Brush-Less DC Fan
AH287 Rev. 10 DS31042
1 of 11 www.diodes.com
APRIL 2010 © Diodes Incorporated
Ordering Information
AH287
HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER...
Similar Datasheet