Termination Insensitive Mixer
www.DataSheet4U.com
Termination Insensitive Mixer, 1 - 4000 MHz
Features
n Intermodulation Ratio is Insensitive to Port...
Description
www.DataSheet4U.com
Termination Insensitive Mixer, 1 - 4000 MHz
Features
n Intermodulation Ratio is Insensitive to Port Mismatches n VSWR: <2.0:1 Typical Midband n Isolation: 35 dB Typical Midband n Impedance: 50 Ohms Nominal n Maximum Input Power: 350 mW Max @ 25°C, Derated n n
V 3.00
MD-/MDC-179
FP-2 (MD-179)
to 85°C @ 3.2 mW/°C LO Power: +24 dBm Max. MIL-STD-883 Screening Available
Description
The unique design of the termination insensitive mixer (TIM) enables it to apply high reverse voltage to diodes during their “off” phase, in the LO cycle. This allows for higher power level performance with minimum distortion. In addition the TIM has internal loads that provide a good match and also absorb mixer generated LO frequency terms. Combined, these features give the mixer its insensitivity to external mismatches, plus superior VSWR.
C-7 (MDC-179)
Pin Configuration (MD-179)
Pin No. 1 2 3 4 Function GND GND GND IF Pin No. 5 6 7 8 Function LO GND GND RF
Termination-Insensitive Mixer, 1 - 4000 MHz
MD-/MDC-179
V 3.00
Electrical Specifications1: TA = -55°C to +85°C
Parameter Frequency Range Conversion Loss 2,3 Test Conditions RF, LO Ports IF Port Frequency 1 - 4000 5 - 1500 5 - 1000 MHz 5 - 2500 MHz 5 - 3500 MHz 1 - 4000 MHz LO to RF LO to IF RF to IF RF Input SSB Noise Figure Typical Two-Tone IM Ratio 3rd Order Intermodulation Ratio Degradation 1 dB Compression 1 dB Desensitization Within 1 dB of Conversion Loss Max with a –10 dBm input, each tone 60 MHz IF @ IF VSWR 3...
Similar Datasheet