SPDT Switch. SW-456 Datasheet

SW-456 Switch. Datasheet pdf. Equivalent

Part SW-456
Description GaAs SPDT Switch
Feature www.DataSheet4U.com GaAs SPDT Switch DC - 3.0 GHz Features n n n n SW-456 Functional Schematic Po.
Manufacture Tyco Electronics
Total Page 4 Pages
Datasheet
Download SW-456 Datasheet



SW-456
GaAs SPDT Switchwww.DataSheet4U.com
DC - 3.0 GHz
Features
n Low Cost Plastic SC-70 (SOT-363) Package
n Low Insertion Loss < 0.3 dB @ 900 MHz
n Low Power Consumption < 15 µA @ +2.3 Volts
n Positive or Negative 2.3 to 8 Volt Control
Description
M/A-COM’s SW-456 is a GaAs monolithic switch in a low
cost SC-70 (SOT-363) surface mount plastic package. The
SW-456 is ideally suited for applications where very low
power consumption, low insertion loss, very small size and
low cost are required. Typical application is in dual band
systems where switching between small signal components
is required such as filter banks, single-band LNA’s,
converters, etc. The SW-456 can be used in applications up
to 0.25 watts in systems such as cellular, PCS, DCS1800,
GSM, CDMA, W-CDMA and other analog/digital wireless
communication systems.
The SW-456 is fabricated using a mature 0.8 micron GaAs
MESFET process. The process features full passivation for
performance and reliability.
Handling Procedures
The following precautions should be observed to avoid
damage:
Static Sensitivity
Gallium Arsenide Integrated Circuits are ESD sensitive
and can be damaged by static electricity. Proper ESD
techniques should be used when handling these devices.
Functional Schematic
Positive Control Voltage
PIN 1
RF1
1000 pF
GND
RF2
1000 pF
Functional Schematic
Negative Control Voltage
PIN 1
RF1
GND
RF2
V1
RFC
1000 pF
V2
V1
RFC
V2
Truth Table
Mode
(Control)
V1
V2
Positive1 0 ± 0.2 V +2.3 to +8 V
+2.3 to +8 V 0 ± 0.2 V
Negative2 0 ± 0.2 V -2.3 V to –8 V
-2.3 V to -8 V 0 ± 0.2 V
RFC -
RF1
Off
On
On
Off
RFC -
RF2
On
Off
Off
On
1. External DC blocking capacitors are required on all RF
ports. 1000 pF capacitors used for positive control voltage.
For higher frequency operation, smaller value DC blocking
capacitors can be substituted.
2. If negative control is used, DC blocking capacitors are not
required on RF ports.
PIN Configuration
PIN Function
Description
1 RF1 RF In/Out
2
GND
RF Ground
3 RF2 RF In/Out
4 V2 VCTRL2
5
RFC
RF Common
6 V1 VCTRL1



SW-456
GaAs SPDT Switch, DC - 3.0 GHz
SW-456
V 2.00
Electrical Specifications: TA = 25 °C, VCTL = 0, -2.3 volts (unless otherwise specified)
Parameter
Test Conditions
Units
Min.
Typ.
Max.
Insertion Loss
DC - 1 GHz
dB 0.35 0.5
1 - 2 GHz
dB 0.45 0.6
2 - 3 GHz
dB 0.56 0.8
Isolation
DC - 1 GHz
dB 20 22
1 - 2 GHz
dB 15 17
2 - 3 GHz
dB 10 12
VSWR
DC - 3 GHz
1.2:1
1.4:1
P1dB (2.3V supply)
500 MHz - 3 GHz
dBm
21
P1dB (3V supply)
Input IP2
500 MHz - 3 GHz
2-Tone 900 MHz, 5 MHz spacing (3.0 V)
dBm
dBm
27
81
Input IP3
TRISE, TFALL
2-Tone 900 MHz, 5 MHz spacing (3.0 V)
10% to 90% RF, 90% to 10% RF
dBm
ns
52
25
TON, TOFF
50% Control to 90% RF, Control to 10% RF
ns
25
Transients
In-Band
mV 25
Gate Leakage
VCTL = 2.3 V
µA 4 15
Absolute Maximum Ratings1
Parameter
Max Input Power (0.5 - 3.0 GHz)
3 V Control
5 V Control
Operating Voltage
Operating Temperature
Storage Temperature
Absolute Maximum
+30 dBm
+33 dBm
+8.5 volts
-40 °C to +85 °C
-65 °C to +150 °C
1. Exceeding any one or combination of these limits may cause
permanent damage.
Specifications subject to change without notice.
n North America: Tel. (800) 366-2266, Fax (800) 618-8883
n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298
n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020
Visit www.macom.com for additional data sheets and product information.
2





@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site (Privacy Policy & Contact)