Document
www.DataSheet4U.com
9939 Via Pasar • San Diego, CA 92126 TEL (858) 621-2700 FAX (858) 621-2722
CLV6115A-LF
VOLTAGE CONTROLLED OSCILLATOR
Rev A1
PHASE NOISE (1 Hz BW, typical)
FEATURES • Frequency Range: 5940 - 6308 MHz • Tuning Voltage: 0.5 - 8 Vdc • MINI-16HT - Style Package APPLICATIONS • Base-stations • Satellite Communications • PERFORMANCE SPECIFICATIONS Oscillation Frequency Range Phase Noise @ 10 kHz offset (1 Hz BW, typ.) Harmonic Suppression (2nd, typ.) Tuning Voltage Tuning Sensitivity (avg.) Power Output Load Impedance Input Capacitance (max.) Pushing
Pulling (14 dB Return Loss, Any Phase)
£(f) (dBc/Hz)
OFFSET (Hz)
VALUE 5940 - 6308 -85 -20 0.5 - 8 105 3±3 50 10 <6 <9 -40 to 85 MINI-16HT 8 23 APPLICATION NOTES Vdc mA pF MHz/V MHz °C UNITS MHz dBc/Hz dBc Vdc MHz/V dBm
Operating Temperature Range Package Style POWER SUPPLY REQUIREMENTS Supply Voltage (Vcc, nom.) Supply Current (Icc, typ.)
All specifications are typical unless otherwise noted and subject to change without notice.
• AN-100/1 : Mounting and Grounding of VCOs • AN-102 : Proper Output Loading of VCOs • AN-107 : How to Solder Z-COMM VCOs
NOTES:
Phase Noise @ 1 kHz offset (1 Hz BW, max.): -82dBc/Hz
© Z-Communications, Inc.
Page 1
All rights reserved
LOW COST - HIGH PERFORMANCE
VOLTAGE CONTROLLED OSCILLATOR
TUNING CURVE, typ.
6520 6480 6440 6400 6360 6320 6280 6240 6200 6160 6120 6080 6040 6000 5960 5920 5880 5840 0 1 2 3 4 5 6
CLV6115A-LF
PAGE 2
FREQUENCY (MHz)
85 25 -40
°c °c °c
7
8
TUNING VOLTAGE (Vdc)
POWER CURVE, typ.
POWER OUTPUT (dBm)
7 6 5 4 3 2 1 0 -1 -2 -3 -4 -5 5883
85 25 -40
°c °c °c
5970
6051
6146
6244
6335
6401
6451
6479
FREQUENCY (MHz)
PHYSICAL DIMENSIONS
P1 Vt P2 RF P3 Vcc
Z-COMM XXXXXXXX-LF W/O# D/C
NOTES
1. The inside radius of all 16 half holes at the perimeter of the board are plated to provide a surf ace for the attachment of the VCO Module to the PCB. 13 pads are f or grounding, 3 pads are f or RFout and pow er supplies. 2. The surf ace of the shield is tin-plated and may be soldered to The shield's base metal is cold rolled steel. 3.The ground plane on the bottom side is ground and attaches to a ground track on the top side of the board as w ell as to the shield. 4. Unless otherw ise noted all dimensions are in inches. 5. Unless otherw ise noted all tolerances are as f ollow s: .xxx = ± .010
© Z-Communications, Inc.
Page 2
Printed in the U.S.A.
.