DatasheetsPDF.com

NSVS792 Dataheets PDF



Part Number NSVS792
Manufacturers New Japan Radio
Logo New Japan Radio
Description JRC SAW FILTER
Datasheet NSVS792 DatasheetNSVS792 Datasheet (PDF)

NSVS792 Dec-01 JRC SAW FILTER NSVS792 Application 1575.42MHz GPS Electrical Specification: (Table 1) The device characteristics are measured in the circuit shown in Fig.1. Table 1. Electrical Specifications Item Spec. Typical Input and Output Impedance 50Ω Nominal Center Frequency (f0) 1575.42MHz Insertion Loss 1574.42~1576.42MHz 3.5dB max. 2.8dB Response Variation 1574.42~1576.42MHz 1.5dB max. 1.0dB Input and Output VSWR 1574.42~1576.42MHz 2.5 max. 1.8 Out of Band Rejection 1475.42MHz 35dB mi.

  NSVS792   NSVS792


Document
NSVS792 Dec-01 JRC SAW FILTER NSVS792 Application 1575.42MHz GPS Electrical Specification: (Table 1) The device characteristics are measured in the circuit shown in Fig.1. Table 1. Electrical Specifications Item Spec. Typical Input and Output Impedance 50Ω Nominal Center Frequency (f0) 1575.42MHz Insertion Loss 1574.42~1576.42MHz 3.5dB max. 2.8dB Response Variation 1574.42~1576.42MHz 1.5dB max. 1.0dB Input and Output VSWR 1574.42~1576.42MHz 2.5 max. 1.8 Out of Band Rejection 1475.42MHz 35dB min. 40dB (Relative to 1535.42MHz 30dB min. 35dB Through Level) 1615.42MHz 30dB min. 40dB 1675.42MHz 40dB min. 45dB (Operating Temperature Range: -40~+85ºC) www.DataSheet4U.com Maximum Rating: (Table 2) Table 2. Maximum Ratings Item Maximum Input Power Maximum DC Voltage Operating Temperature Range Storage Temperature Rating +20dBm 7.5V -40~+85ºC -50~+100ºC Mechanical Specifications: (Fig.2) Package is designed as small as 3.0x3.0x1.0[mm3] for SMD (Surface Mount Device) type. Notice: This part is electrostatic discharge sensitive and may be damaged by improper handling. Communications Equipment Division Communications Equipment Marketing Department 17-22 Akasaka 2-chome minato-ku, Tokyo. 107-0052 Japan Tel. +81 3-3584-8811 Fax. +81 3-3584-8876 http://www.jrc.co.jp/product/comm/deveice/saw/saw_top.html (Japanese) http://www.jrc.co.jp/product/comm/device/saw/saw_top_e.html (English) NSVS792 Dec-01 IN 50Ω 1 6 OUT 50Ω 2 SAW 5 3 4 Fig.1 Measuring circuit (1) 3.0±0.1 www.DataSheet4U.com 3 .0 ±0 .1 JGS (3) (a) (2) 18 (0.60) (b) 2 (1.80) 5 (0 .6 0 ) [2x] 3 4 Marking (1) Manufacture’s Mark (2) Lot Number (a) Year (b) Month *Oct.--- X Nov.--- Y Dec.--- Z (3) Part number Mark Pin no. 1 2 3 4 5 6 Connection GND IN/OUT GND GND OUT/IN GND 1 .0 ±0 .1 1 (0.45) (0.75) 6 [6x] Fig.2 Package dimensions (in mm) 3.8 0.93 2.2 1.15 3.8 0.6 1.15 0.93 Fig.3 Desirable land area (in mm) (0 .5 3 ) [4x] NSVS792 Dec-01 Notice 1. Use this component within operating temperature range. It might not be satisfied with electrical specification without operating temperature range. When it is used less than -40ºC or more than +85ºC, it might be a cause of degradation or destruction of the component. Even if it endures during a short time, it causes degradation of qualification. 2. When soldering iron is used, solder with the temperature at the tip of soldering iron: 350ºC max., the time of soldering: 10 seconds max., the power of soldering iron: 30W max.. 3. Notice that the allowed time of soldering with soldering iron is accumulated time, when soldering is repeated. 4. As rapid temperature change for cleaning after reflow soldering might be a cause of destruction clean this component after confirming that temperature of this component goes down to room temperature. 5. Confirm that there are not any influence for qualification to this component in mounting on PCB when this component is cleaned. 6. As it might be a cause of degradation of destruction to apply static electricity to this component, do not apply static electricity or excessive voltage while assembling and measuring. And do not transport this component with bare hand. 7. As it might be a cause of degradation or destruction to apply D.C. voltage between each terminal, apply D.C. voltage 7.5V max. in actual circuit. www.DataSheet4U.com Note 1. This specification specifies the quality of this component as a single unit. Make sure that this component is evaluated and confirmed against this specification when it is mounted to your products. GPS 1575.42MHz SAW FILTER NSVS792 0 S21 FREQUENCY CHARACTERISTICS 0 2 4 6 8 10 1675.42 Insertion Loss [dB] 20 40 60 80 100 1475.42 S11 Insertion Loss [dB] www.DataSheet4U.com 1575.42 Frequency [MHz] S22 S11 6 5 6 5 S22 VSWR 4 3 2 VSWR 4 3 2 1 1475.42 1575.42 Frequency [MHz] 1 1675.42 1475.42 1575.42 Frequency [MHz] 1675.42 Insertion Loss [dB] 0 20 40 60 0 S21 3000 Frequency [MHz] 6000 Japan Radio Co.,Ltd. (1dB Scale) .


NSVS750 NSVS792 M64886FP


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site.
(Privacy Policy & Contact)