AT69170E

Features www.DataSheet4U.com 4Mbits x1 Non Volatile Memory Designed to Store Field Programmable Gate Arrays (FPGAs) Configurations In-System Programming (ISP) via Two-Wire Bus Simple Interface to SRAM FPGAs Compatible with Atmel AT40KEL040 and ATF280E FPGAs Cascadable Read-back to Support Additional Configurations or Higher-density Arrays Low-power RadHard non volatile CMOS process Programmable Reset Polarity Low-power Dissipation – Active read: 18mW max – Standby mode: 3.6mW max High-reliability – Endurance: 50,000 Write Cycles (page mode) – Data Retention: 10 Years 4Mbits On-chip Flash Array – 512 bytes Page Write No Single Event Latch-up below a LET Threshold of 80MeV/mg/cm2 Tested up to a Total Dose of 60KRads (Si) (according to MIL STD 883 Method 1019) Operating Range: – Voltage: 3V to 3.6V – Temperature: -55 to +125° C Quality Grades: – QML-Q or V – ESCC Package: 305 Mils FP18 Mass: 10 grams Space FPGA Configuration Memory AT69170E 1. Description The AT69170E FPGA configuration memory (configurator) is an electrically erasable and re-programmable RadHard memory organized as 4Mx1bit. It is an easy-to-use and cost-effective configuration memory for space Field Programmable Grid Array (FPGA). It is manufactured with ATMEL 0.18µm low power non volatile CMOS RadHard process. It is packaged in a 18-pin 305 Mils wide Flat Pack package. AT69170E uses a simple serial-access procedure to configure one or more FPGA devices. A two wire interf...