Document
www.DataSheet4U.com
ORDER NO.
ARP3111
PLASMA DISPLAY
PDP-433PE
PDP-433PU
Type
WYVI6 KUC
THIS MANUAL IS APPLICABLE TO THE FOLLOWING MODEL(S) AND TYPE(S).
Model PDP-433PE
? −
PDP-433PU
− ? AC220 - 240V AC120V
Power Requirement
Remarks
This Service Manual should be used together with the following manual(s).
Model No.
PDP-433PE PDP-433PU
Order No.
ARP3112
Remarks
SCHEMATIC DIAGRAM and PCB DIAGRAM
This product is component of system.
Component
Plasma Display System Media Receiver Plasma Display PDP-433HDE PDP-R03E PDP-433PE
System
PDP-4330HD PDP-R03U PDP-433PU
Service Manual
PDP-R03E : ARP3110 PDP-R03U : ARP3113 ARP3111 ARP3112
Remaks
This service manual
For details, refer to "Important symbols for good services".
PIONEER CORPORATION
4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan PIONEER ELECTRONICS (USA) INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A. PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
c PIONEER CORPORATION 2002
T – IZE JAN. 2002 Printed in Japan
PDP-433PE, PDP-433PU
SAFETY INFORMATION www.DataSheet4U.com
This service manual is intended for qualified service technicians ; it is not meant for the casual do-ityourselfer. Qualified technicians have the necessary test equipment and tools, and have been trained to properly and safely repair complex products such as those covered by this manual. Improperly performed repairs can adversely affect the safety and reliability of the product and may void the warranty. If you are not qualified to perform the repair of this product properly and safely, you should not risk trying to do so and refer the repair to a qualified service technician.
WARNING This product contains lead in solder and certain electrical parts contain chemicals which are known to the state of California to cause cancer, birth defects or other reproductive harm. Health & Safety Code Section 25249.6 – Proposition 65
NOTICE (FOR CANADIAN MODEL ONLY) Fuse symbols (fast operating fuse) and/or be of identical designation.
(slow operating fuse) on PCB indicate that replacement parts must
REMARQUE (POUR MODÈLE CANADIEN SEULEMENT) Les symboles de fusible (fusible de type rapide) et/ou de remplacement doivent avoir la même désignation.
(fusible de type lent) sur CCI indiquent que les pièces
SAFETY PRECAUTIONS
NOTICE :Comply with all cautions and safety related notes located on or inside the cabinet and on the chassis. The following precautions should be observed : 1. When service is required, even though the PDP UNIT an isolation transformer should be inserted between the power line and the set in safety before any service is performed. 2. When replacing a chassis in the set, all the protective devices must be put back in place, such as barriers, nonmetallic knobs, adjustment and compartment covershields, isolation resistorcapacitor, etc. 3. When service is required, observe the original lead dr.