TMP86FM25F

www.DataSheet4U.com Comparison table of TMP86CM25F/CS25F/PS25F/C925XB and TMP86CM25AF/FM25F TMP86CM25F/ TMP86CS25F ROM RAM I/O External Interrupt AD Converter Timer Counter Serial Interface LCD Key-on Wakeup Operating Voltage in MCU Mode Operating Temperature in MCU Mode Writing to Flash Memory Package P-QFP100-1420-0.65A N/A 32 K (Mask ROM) 60 K (Mask ROM) 2K 42 pin 5 pin 8-bit AD converter × 8 ch 18-bit timer × 1 ch 8-bit timer × 4 ch 8-bit SIO × 2 ch UART × 1 ch 60 seg × 16 com 4 ch 1.8 to 5.5 V at 4.2 MHz 2.7 to 5.5 V at 8 MHz 4.5 to 5.5 V at 16 MHz −40 to 85℃ − FBGA272 1.8 to 5.25 V at 4.2 MHz 2.7 to 5.25 V at 8 MHz 4.5 to 5.25 V at 16 MHz 0 to 60°C TMP86PS25F 60 K (OTP) TMP86C925XB (Emulation chip) − − 42 pin (MCU part) TMP86FM25F 32 K (Flash) 2K 42 pin 5 pin Difference TMP86CM25AF 32 K (Mask ROM) 8-bit AD converter × 8 ch (Note 3) 18-bit timer × 1 ch 8-bit timer × 4 ch 8-bit SIO × 2 ch UART × 1 ch 60 seg × 16 com (Note 4) 4 ch 1.8 to 3.6 V at 4.2 MHz (External clock) 1.8 to 3.6 V at 8 MHz (Resonator) 2.7 to 3.6 V at 16 MHz −40 to 85°C 2.7 to 3.6V at 16 MHz 25°C ± 5°C Available (Note 2) − P-QFP100-1420-0.65A CPU Wait (Note 1) Note 1: The CPU wait is a CPU halt function for stabilizing of power supply of Flash memory. The CPU wait period is as follows. In the CPU wait period except RESET, CPU is halted but peripheral functions are not halted. Therefore, if the interrupt occurs during the CPU wait period, the interrupt latch is set. In this case, if the IMF has bee...