DatasheetsPDF.com

LPS353-CEF Dataheets PDF



Part Number LPS353-CEF
Manufacturers Emerson
Logo Emerson
Description AC-DC / 261W - 500W
Datasheet LPS353-CEF DatasheetLPS353-CEF Datasheet (PDF)

350 Watts LPS350 Series Total Power: 350 Watts Input Voltage: 85-264 VAC 120-300 VDC # of Outputs: Single Electrical Specs Input Input range Frequency Inrush current Efficiency EMI filter 85-264 VAC; 120-300 VDC 47-440 Hz 38 A max., cold start @ 25°C 75% typical at full load FCC Class B conducted and radiated CISPR 22 Class B conducted and radiated EN55022 Class B conducted and radiated VDE 0878 PT3 Class B conducted and radiated. 0.99 typical <0.5 mA @ 50/60 Hz, 264 VAC input Power factor Sa.

  LPS353-CEF   LPS353-CEF


Document
350 Watts LPS350 Series Total Power: 350 Watts Input Voltage: 85-264 VAC 120-300 VDC # of Outputs: Single Electrical Specs Input Input range Frequency Inrush current Efficiency EMI filter 85-264 VAC; 120-300 VDC 47-440 Hz 38 A max., cold start @ 25°C 75% typical at full load FCC Class B conducted and radiated CISPR 22 Class B conducted and radiated EN55022 Class B conducted and radiated VDE 0878 PT3 Class B conducted and radiated. 0.99 typical <0.5 mA @ 50/60 Hz, 264 VAC input Power factor Safety ground leakage current Special Features • • • • • • • • • • • • • • • • Active power factor correction IEC EN6100-3-2 compliance Remote sense Power fail and remote inhibit Single wire current sharing Built-in EMI filter Low output ripple Supervisory output 5 V and 12 V Overvoltage protection Overload protection Thermal overload protection DC power good Cover -C 130 KHz switching frequency Optional with fan cover -CF Optional end-mounted fan - CEF Output Maximum power With cover: 350 W with 30 CFM forced air, (-C) (-CF) (-CEF) 2:1 wide ratio 5 V @ 500 mA regulated, 12 V @ 150 20 ms @ 350 W load, 115 VAC nominal line at factory voltage setting Short circuit protection on all outputs. Case overload protected @ 110-145% above peak rating 5 V output: 5.7-6.7 VDC. Other models 10% to 25% above nominal output TTL logic signal goes high 50-150 msec after 5 V output. It goes low at least 4 msec before loss of regulation Requires an external contact (N.O or N.C) to inhibit outputs TTL logic goes high 50-150 msec after the output. It goes low when there is loss of regulation. Compensates for 0.5 V lead drop min. Will operate without remote sense connected. Reverse connection protected. Adjustment range Supervisory outputs mA x2 Hold-up time Overload protection Overvoltage protection Logic Control Power failure Environmental Operating temperature: 0° to 50°C ambient derate each output at 2.5% per degree from 50° to 70°C Electromagnetic susceptibility: Designed to meet IEC 801, -2, -3, -4, -5, -6, Level 3 Humidity: Operating; non-condensing 5% to 95% Vibration: Three orthogonal axes, sweep at 1 oct/min, 5 min. dwell at four major resonances 0.7 G peak 5 Hz to 500 Hz, operational Storage temperature: -40° to 85°C Temperature coefficient: ±.04% per °C MTBF demonstrated: >550,000 hours at full load and 25°C ambient conditions Remote on/off DC-OK Remote sense Safety VDE UL UL1950 CSA NEMKO BABT CB CE 0805/EN60950 (IEC950) E186249 CSA 22.2-234 Level 5 EN 60950/EMKO-TUE (74-sec) 203 EN60950/BS7002 Certificate and report Mark (LVD) 21310-3336-0001 LR109492C P98102115 608857, 608858, 609097 5734, 6280, 6281 rev 07.11.05 128 Technical Support: (888) 41-ASTEC or (407) 241-2752 Americas: (760) 930-4600 Europe (UK) 44 (1384) 842-211 Asia (HK) 852-2437-9662 AMERICAS 5810 Van Allen Way Carlsbad, CA 92008 Telephone: 760-930-4600 Facsimile: 760-930-0698 EUROPE Astec House, Waterfront Business Park Merry Hill, Dudley West Midlands, DY5 1LX, UK Telephone: 44 (1384) 842-211 Facsimile: 44 (1384) 843-355 ASIA Units 2111-2116, Level 21 Tower1, Metroplaza 223, Hing Fong Road Kwai Fong, New Territories Hong Kong Telephone: 852-2437-9662 Facsimile: 852-2402-4426 LPS350 Series Ordering Information Model Number LPS352-C LPS353-C LPS354-C LPS355-C 1. 2. 3. 4. Output Voltage 5 V (3-6 V) 12 V (6-12 V) 15 V (12-24 V) 24 V ( 24-48 V) Minimum Load 0A 0A 0A 0A Maximum Load with 30 CFM Forced Air 70 A 29.2 A 23.3 A 14.6 A Peak Load1 80 A 33 A 26 A 16 A Regulation2 Ripple P/P (PARD)3 ±2% ±2% ±2% ±2% 50 mV 120 mV 150 mV 240 mV Peak current lasting <30 seconds with a maximum 10% duty cycle. At 25°C including initial tolerance, line voltage, load currents and output voltages adjusted to factory settings. Peak-to-peak with 20 MHz bandwidth and 10 µF in parallel with a 0.1 µF capacitor at rated line voltage and load ranges. If optional CF or CEF fans are not used, 30CFM forced air cooling needs to be provided and is required through the length of the power supply. Not convection rated. 5. Output voltage adjustment requires a 1A load. 6. Remote inhibit resets OVP latch. Note: -CF suffix added to the model number indicates cover with yop fan; -CEF suffix added to model number indicates end-mounted fan chassis. Pin Assignments Connector SK1 PIN 1 PIN 2 PIN 3 PIN 1 PIN 2 PIN 3 PIN 4 PIN 5 PIN 6 PIN 7 PIN 8 PIN 9 PIN 10 PIN 1 PIN 2 PIN 1 PIN 2 PIN 1 PIN 2 Neutral Line Ground N/C N/C + Sense – Sense POK C.Share DC-OK Inhibit (N.O.) Inhibit (N.C.) COM + 5V aux (5V @ 100mA) – Common +Fan 1 (12 V @ 150mA) – Common + Fan 2 (12V @ 150mA) – Common SK3 6-32 (2 places) Main Output Terminal Block TB1 +ve -ve M3 (4 places) M3 (6 places) SK3 1234 5 678910 #6-32 UNC (8 places) .24 (6.1) SK6 Fan SK5 Fan SK4 (5V aux) 3.68 (93.6) 5.46 (138.6) 6.64 (168.6) (-CF) Cover with fan 3.15 (80) 8.52 (216.4) 9.0 (228.6) 10.78 (273.8) 2.17 (55) J1 SK4 SK5 SK6 Mating Connectors SK3 Molex 22-01-1104 PINS:08-70-0057 SK4 Molex 22-01-3027 PINS: 08-50-0114 6-32 (3 places) 3 2.


LPS353-C LPS353-CEF LPS353-CF


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site.
(Privacy Policy & Contact)