NTQ163

50-165 Watts NTQ160 Series Total Power: 50-165 Watts Input Voltage: 85-264 VAC # of Outputs: Quad Electrical Specs Input Input range Frequency Inrush current Efficiency EMI filter 85-264 VAC 47-63 Hz 38 A max., cold start @ 25°C 65% typical at full load @ 115 VAC input FCC Class B conducted and radiated, CISPR 22 Class B conducted and radiated, EN55022 Class B conducted and radiated, VDE 0878 PT3 Class B conducted and radiated. 0.99 typical <1 mA @ 50/60 Hz, 264 VAC input Power factor Safety ground leakage current Special Features Active power factor correction EN61000-3-2 compliance Remote sense on outputs one and two Power fail and remote inhibit 5V Standby output DC Power good Single wire current sharing on outputs one and two Wide range adjustable on outputs 1 & 2 Built-in Class B EMI filter Overvoltage protection Overload protection Thermal overload protection Outputs 3 & 4 are floating Output Maximum power Adjustment range Hold-up time Overload protection 50W convection, 165 W with 30 CFM forced air 1.8V - 3.5V; 3.0V - 5.5V on outputs one and two 20 ms @ 165 W load Short circuit protection on all outputs. Case overload protected @ 110-145% above peak rating. Latching type recycle AC to reset. Tracks outputs 1 & 2: 20% to 35% above output setting 5V@ 2 A regulated ±5% Overvoltage protection Standby output Logic Control Power failure Remote Inhibit Remote sense TTL logic signal goes high 100-500 msec after V1 output; it goes low at least 4...