Document
APDS-9007
Ambient Light Photo Sensor with Logarithmic Current Output
Data Sheet
Description
The APDS-9007 is an analog current output Ambient Light Photo Sensor, packaged in a miniature chipLED lead-free surface mount package. This device provides a Logarithmic response over a wide dynamic range of 3 lux to 70K lux and has a low sensitivity variation across various light sources. It is well suited for applications that operates under high ambient brightness.
Features
• Excellent responsivity Close responsivity to the human eye • Miniature ChipLED Leadfree surface-mount package Height – 0.8 mm Length – 2.4 mm Width – 2.0 mm • Low sensitivity variation across various light sources • Operating temperature : -40°C to 85°C • Vcc supply 2 to 3.6V • Lead-free package with RoHS compliance • Photo current response to wide dynamic range of 3 lux to 70K lux
Application Support Information
The Application Engineering Group is available to assist you with the application design associated with APDS9007 ambient light photo sensor module. You can contact them through your local sales representatives for additional details.
Applications
• Detection of ambient light to control display backlighting Mobile devices – Mobile phones, PDAs Computing devices – Notebooks, Webpads Consumer devices – TVs, Video Cameras, Digital Still Camera • Automatic Residential and Commercial Lighting Management • Electronic Signs and Signals
www.DataSheet4U.com
Ordering Information
Part Number APDS-9007-020 Packaging Type Tape and Reel Package 6-pins Chipled package Quantity 2500
Typical Application Circuit
Pin 4: VCC
I/O Pins Configuration Table
Pin 1
Pin 3: OUT
Symbol Gnd NC * Out Vcc NC * SD
Description Ground No Connect Output Supply Voltage No Connect Shutdown (Active High)
Pin 6: SD
APDS9007
2 3 4
RLoad
Pin 1: GND
5 6
GND
GND
Figure 1. Typical application circuit for APDS-9007 (RLoad = 27 K Ohm)
Absolute Maximum Ratings
For implementations where case to ambient thermal resistance is ± 50 °C /W Parameter Storage Temperature Supply Voltage Symbol TS VCC Min. -40 0 Max. 85 3.6 Units °C V
www.DataSheet4U.com Recommended Operating Conditions
Parameter Operating Temperature Supply Voltage
Symbol TA VCC
Min. -40 2
Max. 85 3.6
Units °C V
Conditions
CAUTION: It is advised that normal static precautions be taken in handling and assembly of this component to prevent damage and/or degradation which may be induced by ESD
Electrical & Optical Specifications (Ta=25C) :
Parameter Supply Current Photo Current output (I) Photo Current output (II) Light Current Ratio Rise Time Fall Time Peak sensitivity wavelength SD Current Output Compliance Voltage Symbol Icc I_PH1 I_PH2 I_PH2 / I_PH1 Tr Tf l Icc-SD Vout Vcc-0.5 21 Min. Typ. 230 30 36 1.2 0.2 0.2 560 1 mSec mSec nm µA Volts Vcc=3V, SD=3V RLoad=100K, Vcc=3V (Refer Figure 7) Rload = 27K ohms, 1K lux,Vcc = 3V Rload = 27K ohms, 1K lux, Vcc = 3V 39 Max. Units µA uA Conditions LUX=1K, Vcc=3V L.