DOUBLE CHANNEL HIGH SIDE DRIVER
www.DataSheet4U.com
VND830-E
DOUBLE CHANNEL HIGH SIDE DRIVER
Table 1. General Features
Type VND830-E
(*) Per each chann...
Description
www.DataSheet4U.com
VND830-E
DOUBLE CHANNEL HIGH SIDE DRIVER
Table 1. General Features
Type VND830-E
(*) Per each channel
Figure 1. Package
Iout 6A (*) VCC 36V
RDS(on) 60mΩ (*)
CMOS COMPATIBLE INPUTS OPEN DRAIN STATUS OUTPUTS ■ ON STATE OPEN LOAD DETECTION ■ OFF STATE OPEN LOAD DETECTION ■ SHORTED LOAD PROTECTION ■ UNDERVOLTAGE AND OVERVOLTAGE SHUTDOWN ■ LOSS OF GROUND PROTECTION ■ VERY LOW STAND-BY CURRENT
■ ■
SO-16L
REVERSE BATTERY PROTECTION (**) ■ IN COMPLIANCE WITH THE 2002/95/EC EUROPEAN DIRECTIVE
■
DESCRIPTION The VND830-E is a monolithic device made by using STMicroelectronics VIPower M0-3 Technology, intended for driving any kind of load with one side connected to ground. Active V CC pin voltage clamp protects the devices against low energy spikes (see ISO7637 transient compatibility table).
Active current limitation combined with thermal shutdown and automatic restart protects the device against overload. The device detects open load condition both is on and off state. Output shorted to VCC is detected in the off state. Device automatically turns off in case of ground pin disconnection.
Table 2. Order Codes
Package Tube VND830-E Tape and Reel VND830TR-E
SO-16L
Note: (*) See application schematic at page 9
Rev. 3 February 2005 1/20
VND830-E
www.DataSheet4U.com
Figure 2. Block Diagram
VCC
VCC CLAMP
OVERVOLTAGE UNDERVOLTAGE
GND INPUT1 STATUS1
CLAMP 1 OUTPUT1 DRIVER 1 CLAMP 2 CURRENT LIMITER 1 LOGIC OVERTEMP. 1 OPENLOAD ON 1 CURRENT LIMITER 2 DRIVER 2 ...
Similar Datasheet