INIC-1608

USB to SATA Bridge Overview The INIC-1608 provides an advanced solution to connect SATA devices to www.DataSheet4U.com USB Host with integrated CPU and embedded SRAM/ROM. To provide high performance and cost effective solution, the INIC-1608 integrates USB-PHY, Mass Storage Class BulkOnly USB function, SATA link/PHY core and microprocessor into a single ASIC. The INIC-1608 provides the data transfer rate of up to 60 MB/sec connecting to a 1.5G SATA interface. USB 1.1 and USB 2.0 compliant. USB Mass Storage Class Bulk-Only Transport Specification Compliant. SATA specification 1.0, SATA II Compliant (Hot Plug is supported). Support SATA BIST through USB and SATA bus Support ATA/ATAPI device DMA and PIO mode. 2k bytes of data buffer for data transfer. On-Chip 3.3V to 1.8V regulator and 5V to 3.3V regulator. 48 pin LQFP Feature Summary Integrates USB2.0 PHY IP core. Data transfer rate of up to 60 MB/sec. Integrated internal Turbo 8051 uP with 24KB embedded ROM and 2KB SRAM. External NVRAM supported (optional). Support HID. Up to 8 GPIO pins. Use a single crystal for both USB and SATA Supports SATA (bridged SATA) Hard Disk drives, CD-RW devices, DVDs, Removable media devices, BD drive(Blue Ray) Firmware/Software Support USB Mass Storage Class Bulk-Only Transport support Provide software utilities for NVRAM upgraded. Devices Support Hard disk drives CD-RW devices DVDs Removable media devices BD(Blu-ray Disc) Drive Block Diagram US...