32-Bit Single-Chip Microcontroller
www.DataSheet4U.com
Preliminary User's Manual
V850ES/JJ2
32-Bit Single-Chip Microcontrollers Hardware
µPD70F3720 µPD7...
Description
www.DataSheet4U.com
Preliminary User's Manual
V850ES/JJ2
32-Bit Single-Chip Microcontrollers Hardware
µPD70F3720 µPD70F3721 µPD70F3722 µPD70F3723 µPD70F3724
Document No. U17714EJ1V0UD00 (1st edition) Date Published October 2005 N CP(K) 2005 Printed in Japan
[MEMO]
www.DataSheet4U.com
2
Preliminary User's Manual U17714EJ1V0UD
NOTES FOR CMOS DEVICES
www.DataSheet4U.com
1
VOLTAGE APPLICATION WAVEFORM AT INPUT PIN Waveform distortion due to input noise or a reflected wave may cause malfunction. If the input of the CMOS device stays in the area between VIL (MAX) and VIH (MIN) due to noise, etc., the device may malfunction. Take care to prevent chattering noise from entering the device when the input level is fixed, and also in the transition period when the input level passes through the area between VIL (MAX) and VIH (MIN).
2
HANDLING OF UNUSED INPUT PINS Unconnected CMOS device inputs can be cause of malfunction. If an input pin is unconnected, it is possible that an internal input level may be generated due to noise, etc., causing malfunction. CMOS devices behave differently than Bipolar or NMOS devices. Input levels of CMOS devices must be fixed high or low by using pull-up or pull-down circuitry. Each unused pin should be connected to VDD or GND via a resistor if there is a possibility that it will be an output pin. All handling related to unused pins must be judged separately for each device and according to related specifications governing the device.
3
PRECAU...
Similar Datasheet