TJA1054A

TJA1054A Fault-tolerant CAN transceiver Rev. 05 — 29 September 2009 www.DataSheet4U.com Product data sheet 1. General description The TJA1054A is the interface between the protocol controller and the physical bus wires in a Controller Area Network (CAN). It is primarily intended for low-speed applications up to 125 kBd in passenger cars. The device provides differential receive and transmit capability but will switch to single-wire transmitter and/or receiver in error conditions. The TJA1054A is the ElectroStatic Discharge (ESD) improved version of the TJA1054. The TJA1054AT is, as the TJA1054T, pin and downwards compatible with the PCA82C252T and the TJA1053T. This means that these two devices can be replaced by the TJA1054AT or the TJA1054T with retention of all functions. The most important improvements of the TJA1054 and the TJA1054A with respect to the PCA82C252 and the TJA1053 are: Very low ElectroMagnetic Emission (EME) due to a very good matching of the CANL and CANH output signals Good ElectroMagnetic Emission (EMI), especially in low power modes Full wake-up capability during bus failures Extended bus failure management including short-circuit of the CANH bus line to VCC Support for easy system fault diagnosis Two-edge sensitive wake-up input signal via pin WAKE 2. Features 2.1 Optimized for in-car low-speed communication I I I I Baud rate up to 125 kBd Up to 32 nodes can be connected Supports unshielded bus wires Very low ElectroMagnetic Emission...