Positive High-Voltage Hot Swap Controller /Sequencer
MIC2586/MIC2586R
www.DataSheet4U.com Single-Channel, Positive High-Voltage Hot Swap Controller/Sequencer
General Descri...
Description
MIC2586/MIC2586R
www.DataSheet4U.com Single-Channel, Positive High-Voltage Hot Swap Controller/Sequencer
General Description
The MIC2586 and MIC2586R are single-channel positive voltage hot swap controllers/sequencers designed to provide safe insertion and removal of boards for systems that require live (always-powered) backplanes. These devices use few external components and act as controllers for external Nchannel power MOSFET devices to provide inrush current control and output voltage slew rate control. Overcurrent fault protection is provided via programmable analog foldback current limit circuitry equipped with a programmable overcurrent filter. These protection circuits combine to limit the power dissipation of the external MOSFET to insure that the MOSFET is in its SOA during fault conditions. The MIC2586 provides a circuit breaker function that latches the output MOSFET off if the load current exceeds the current limit threshold for the duration of the programmable timer. Conversely, the MIC2586R will attempt to restart power after a load current fault with a low duty cycle to prevent the MOSFET from overheating. Each device provides either an active-HIGH (-1BM) or an active-LOW (-2BM) “Power-isGood” signal. The MIC2586 and the MIC2586R provide up to three, time-sequenced "Power-is-Good" outputs that can be used as a control for dc-dc converter circuits or power modules. Data sheets and support documentation can be found on Micrel’s web site at www.micrel.com.
Fea...
Similar Datasheet