DOUBLE CHANNEL HIGH SIDE DRIVER
www.DataSheet4U.com
VND810-E
DOUBLE CHANNEL HIGH SIDE DRIVER
Table 1. General Features
Type VND810-E RDS(on) 160 mΩ (*)...
Description
www.DataSheet4U.com
VND810-E
DOUBLE CHANNEL HIGH SIDE DRIVER
Table 1. General Features
Type VND810-E RDS(on) 160 mΩ (*)
Figure 1. Package
Iout
3.5A (*)
VCC
36 V
(*) Per each channel
s
CMOS COMPATIBLE INPUTS OPEN DRAIN STATUS OUTPUTS s ON STATE OPEN LOAD DETECTION s OFF STATE OPEN LOAD DETECTION s SHORTED LOAD PROTECTION s UNDERVOLTAGE AND OVERVOLTAGE SHUTDOWN s PROTECTION AGAINST LOSS OF GROUND s VERY LOW STAND-BY CURRENT
s
SO-16
REVERSE BATTERY PROTECTION (**) s IN COMPLIANCE WITH THE 2002/95/EC EUROPEAN DIRECTIVE
s
DESCRIPTION The VND810-E is a monolithic device designed in STMicroelectronics VIPower M0-3 Technology, intended for driving any kind of load with one side connected to ground. Active V CC pin voltage clamp protects the device against low energy spikes (see ISO7637 transient compatibility table).
Active current limitation combined with thermal shutdown and automatic restart protects the device against overload. The device detects open load condition both in on and off state. Output shorted to VCC is detected in the off state. Device automatically turns off in case of ground pin disconnection.
Table 2. Order Codes
Package Tube
VND810-E
Tape and Reel
VND810TR-E
SO-16
Note: (**) See application schematic at page 9
Rev. 1 October 2004 1/20
VND810-E
Figure 2. Block Diagram
www.DataSheet4U.com
Vcc
Vcc CLAMP
OVERVOLTAGE UNDERVOLTAGE
GND INPUT1 STATUS1
CLAMP 1 OUTPUT1 DRIVER 1 CLAMP 2 CURRENT LIMITER 1 OVERTEMP. 1 LOGIC OPENLOAD ON 1 CURRENT LIMITER 2...
Similar Datasheet