DOUBLE CHANNEL HIGH SIDE SOLID STATE RELAY
www.DataSheet4U.com
VND920-E
DOUBLE CHANNEL HIGH SIDE SOLID STATE RELAY
Table 1. General Features
Type VND920-E RDS(on)...
Description
www.DataSheet4U.com
VND920-E
DOUBLE CHANNEL HIGH SIDE SOLID STATE RELAY
Table 1. General Features
Type VND920-E RDS(on) 16mΩ IOUT 35 A (*) VCC 36 V
Figure 1. Package
(*) Per channel with all the output pins connected to the PCB.
CMOS COMPATIBLE INPUT s PROPORTIONAL LOAD CURRENT SENSE s SHORTED LOAD PROTECTION s UNDERVOLTAGE AND OVERVOLTAGE SHUTDOWN s OVERVOLTAGE CLAMP s THERMAL SHUTDOWN s CURRENT LIMITATION s PROTECTION AGAINST LOSS OF GROUND AND LOSS OF VCC
s s s s
SO-28 (DOUBLE ISLAND)
VERY LOW STAND-BY POWER DISSIPATION
REVERSE BATTERY PROTECTION (**) IN COMPLIANCE WITH THE 2002/95/EC EUROPEAN DIRECTIVE
Active current limitation combined with thermal shutdown and automatic restart protect the device against overload. Built-in analog current sense output delivers a current proportional to the load current. Device automatically turns off in case of ground pin disconnection.
DESCRIPTION The VND920-E is a double chip device made by using STMicroelectronics VIPower M0-3 Technology, intended for driving any kind of load with one side connected to ground. Active VCC pin voltage clamp protects the device against low energy spikes (see ISO7637 transient compatibility table). Table 2. Order Codes
Package Tube VND920-E Tape and Reel VND920TR-E
PowerSO-10
Note: (**) See application schematic at page 9.
Rev. 1 October 2004 1/19
VND920-E
Figure 2. Block Diagram
www.DataSheet4U.com
VCC 1
VCC CLAMP
OVERVOLTAGE DETECTION UNDERVOLTAGE DETECTION
GND 1
Power CLAMP
DRIVER I...
Similar Datasheet