Fm+ I2C-bus stepper motor controller
PCA9629
Fm+ I2C-bus stepper motor controller
Rev. 1 — 29 February 2012 Product data sheet
1. General description
The PC...
Description
PCA9629
Fm+ I2C-bus stepper motor controller
Rev. 1 — 29 February 2012 Product data sheet
1. General description
The PCA9629 is an I2C-bus controlled low-power CMOS device that provides all the logic and control required to drive a four phase stepper motor. PCA9629 is intended to be used with external high current drivers to drive the motor coils. The PCA9629 supports three stepper motor drive formats: one-phase (wave drive), two-phase, and half-step. In addition, when used as inputs, four General Purpose Input/Outputs (GPIOs) allow sensing of logic level output from optical interrupter modules and generate active LOW interrupt signal on the INT pin of PCA9629. This is a useful feature in sensing home position of motor shaft or reference for step pulses. Upon interrupt, the PCA9629 can be programmed to automatically stop the motor or reverse the direction of rotation of motor. Output wave train is programmable using control registers. The control registers are programmed via the I2C-bus. Features built into the PCA9629 provide highly flexible control of stepper motor, off-load bus master/micro and significantly reduce I2C-bus traffic. These include control of step size, number of steps per single command, number of full rotations and direction of rotation. A ramp-up on start and/or ramp-down on stop is also provided. The PCA9629 is available in a 16-pin TSSOP package and is specified over the 40 C to +85 C industrial temperature range.
www.DataSheet.net/
2. Features and ...
Similar Datasheet