Audio Power Amplifier
APA2071
Stereo 3.1W Non-inverting Audio Power Amplifier(with DC Volume Control)
Features
General Description
• Non-I...
Description
APA2071
Stereo 3.1W Non-inverting Audio Power Amplifier(with DC Volume Control)
Features
General Description
Non-Inverting Audio Power Amplifier
The APA2071 is a monolithic integrated circuit, which
Low Operating Current about 9mA (Typical) Improved Depop Circuitry to Eliminate Turn-On
and Turn-Off Transients in Outputs
32-Step Volume Adjustable by DC Voltage
with Hysteresis
Output Power
provides precise DC volume control, and a stereo bridged audio power amplifiers capable of producing 2.6W (2W) into 4Ω with less than 10% (1.0%) THD+N. The attenuator range of the volume control in APA2071 is from 18dB (VVOLUME=0V) to -80dB (VVOLUME=3.54V) with 32 steps. The advantage of internal gain setting can be less components and PCB area. Both the depop circuitry and
at 1% THD+N
the thermal shutdown protection circuitry are integrated
- 2.4W, at VDD=5V, BTL Mode, RL=3Ω
-
2W,
at
V =5V, DD
BTL
Mode,
RL=4Ω
at 10% THD+N
in the APA2071, that reduce pops and clicks noise during power up or shutdown mode operation. It also improves the power off pop noise and protects the chip be-
- 3.1W, at VDD=5V, BTL Mode, RL=3Ω
ing destroyed by over temperature and short current
- 2.6W, at VDD=5V, BTL Mode, RL=4Ω Two Output Modes: BTL and SE Modes Selected
failure. To simplify the audio system design, the APA2071 combines a stereo bridge-tied load (BTL) mode for
speaker drive and a stereo single-end (SE) mode for head-
by SE/BTL Pin
phone drive into a single chip, wh...
Similar Datasheet