Document
www.eicsemi.com
GBU8005 ~ GBU810
TH97/2478
TH09/2479
IATF 0113686 SGS TH07/1033
Glass Passivated Single-Phase Bridge Rectifiers
PRV : 50 - 1000 Volts Io : 8.0 Amperes
FEATURES :
* Glass passivated chip junction * Ideal for printed circuit board * Plastic material has Underwriters Laboratory
Flammability Classification 94V-0 * Reliable low cost construction utilizing molded
plastic technique * Pb / RoHS Free
MECHANICAL DATA :
* Case: Molded plastic, GBU * Epoxy: UL 94V-O rate flame retardant * Terminals: Leads solderable per MIL-STD-202,
method 208 guaranteed * Mounting position: Any * Weight: 0.15ounce, 4.0gram
GBU
0.880 (22.30) 0.860 (21.80) 0.161 (4.10) 0.138 (3.50)
0.311 (7.90) 0.291 (7.40)
R 7.6
~ ~+
0.093 (2.35) 0.077 (1.95)
0.050 (1.27) 0.040 (1.02)
3.2 x 45°
0.085 (2.16) 0.065 (1.65) 0.108 (2.75) 0.089 (2.25)
0.709 (18.00) 0.689 (17.50)
0.210(5.33) 0.190(4.83)
0.210(5.33) 0.190(4.83)
0.210(5.33) 0.190(4.83)
0.140 (3.56) 0.130 (3.30)
7o 0.740 (18.80) 0.720 (18.30)
7o
0.022(0.56) 0.018(0.46)
0.039(1.00) 0.030(0.76)
Dimensions in inches and ( millimeter )
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Rating at 25 °C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load.
For capacitive load, derate current by 20%.
RATING
Maximum Recurrent Peak Reverse Voltage
SYMBOL
GBU 8005
VRRM
50
GBU 801
100
GBU 802
200
GBU 804
400
GBU 806
600
GBU 808
800
GBU 810
1000
UNIT V
Maximum RMS Voltage
VRMS
35 70 140 280 420 560 700
V
Maximum DC Blocking Voltage
VDC
50 100 200 400 600 800 1000 V
Maximum Average Forward Output Current Tc=100 °C (1) IF(AV)
8.0
A
Peak Forward Surge Current, 8.3ms Single half sine-
wave Superimposed on rated load (JEDEC Method)
IFSM
200
A
Maximum Forward Voltage at IF = 8 A
VF
1.0
V
Maximum DC Reverse Current
Ta = 25 °C
IR
5.0 µA
at Rated DC Blocking Voltage
TTa = 125 °C
IR(H)
500
Typical Junction capacitance per element (Note3)
CJ
225
125
pF
Typical Thermal Resistance (Note 4) Typical Thermal Resistance (Note 4) Operating Junction and Storage Temperature Range
RѲJA RѲJC TJ, TSTG
21 2.2 - 55 to + 150
°C/W °C/W
°C
Notes :
(1) Units case mounted on 3.2 x 3.2 x 0.12" thick (8.2 x 8.2 x 0.3cm) Al plate heatsink
(2) Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screws
(3) Measured at 1 MHz and applied reverse voltage of 4.0 VDC
(4) Units mounted in free air, no heatsink on P.C.B., 0.5 x 0.5” (12 x 12mm) copper pads, 0.375" lead length
Page 1 of 2
Rev. 03 : September 20, 2010
www.eicsemi.com
TH97/2478
TH09/2479
RATING AND CHARACTERISTIC CURVES ( GBU8005 - GBU810 )
IATF 0113686 SGS TH07/1033
AVERAGE FORWARD OUTPUT CURRENT, AMPERES
FIG.1 - DERATING CURVE FOR OUTPUT RECTIFIED CURRENT
10 60 Hz, Resistive or inductive load.
8.0
6.0
4.0
2.0 Heatsink mounted on 3.2 x 3.2 x 0.12" thick (8.2 x 8.2 x 0.3cm) Al plate
0 0 25 50 75 100 125 150 175
CAS.