PIC18F25K80

PIC18F66K80 FAMILY 28/40/44/64-Pin, Enhanced Flash Microcontrollers with ECAN™ XLP Technology Power-Managed Modes: Run: CPU on, Peripherals on Idle: CPU off, Peripherals on Sleep: CPU off, Peripherals off Two-Speed Oscillator Start-up Fail-Safe Clock Monitor (FSCM) Power-Saving Peripheral Module Disable (PMD) Ultra Low-Power Wake-up Fast Wake-up, 1 s, Typical Low-Power WDT, 300 nA, Typical Run mode Currents Down to Very Low 3.8 A, Typical Idle mode Currents Down to Very Low 880 nA, Typical Sleep mode Current Down to Very Low 13 nA, Typical ECAN Bus Module Features: Conforms to CAN 2.0B Active Specification Three Operating modes: - Legacy mode (full backward compatibility with existing PIC18CXX8/FXX8 CAN modules) - Enhanced mode - FIFO mode or programmable TX/RX buffers Message Bit Rates up to 1 Mbps DeviceNet™ Data Byte Filter Support Six Programmable Receive/Transmit Buffers Three Dedicated Transmit Buffers with Prioritization Two Dedicated Receive Buffers TABLE 1: DEVICE COMPARISON ECAN Bus Module Features (Continued): 16 Full, 29-Bit Acceptance Filters with Dynamic Association Three Full, 29-Bit Acceptance Masks Automatic Remote Frame Handling Advanced Error Management Features Special Microcontroller Features: Operating Voltage Range: 1.8V to 5.5V On-Chip 3.3V Regulator Operating Speed up to 64 MHz Up to 64 Kbytes On-Chip Flash Program Memory: - 10,000 erase/write cycle, typical - 20 years minimum retention, typica...