ATB Series Balun Transformers
R F
C o m p o n e n t s
July 2013
Balun Transformers
Wound SMD
ATB series
ATB2012-50011 (2.0u1.2u1.2mm) ATB2012-75011...
Description
R F
C o m p o n e n t s
July 2013
Balun Transformers
Wound SMD
ATB series
ATB2012-50011 (2.0u1.2u1.2mm) ATB2012-75011 (2.0u1.2u1.2mm) ATB2012E-50011M (2.0u1.2u1.0mm) ATB2012E-75011M (2.0u1.2u1.0mm)
Free Datasheet http://www.nDatas
(2/13)
R F
C o m p o n e n t s
REMINDERS FOR USING THESE PRODUCTS
Before using these products, be sure to request the delivery specifications.
SAFETY REMINDERS
Please pay sufficient attention to the warnings for safe designing when using these products.
REMINDERS
The storage period is less than 6 months. Be sure to follow the storage conditions (Temperature: 5 to 40°C, Humidity: 10 to 75% RH or less). If the storage period elapses, the soldering of the terminal electrodes may deteriorate. Do not use or store in locations where there are conditions such as gas corrosion (salt, acid, alkali, etc.). Before soldering, be sure to preheat components. The preheating temperature should be set so that the temperature difference between the solder temperature and chip temperature does not exceed 150°C. Soldering corrections after mounting should be within the range of the conditions determined in the specifications. If overheated, a short circuit, performance deterioration, or lifespan shortening may occur. When embedding a printed circuit board where a chip is mounted to a set, be sure that residual stress is not given to the chip due to the overall distortion of the printed circuit board and partial distortion such as at screw tightening portions....
Similar Datasheet