BII112S-20000

ROTOR DIMENSIONS AA-225857/01 MODEL BiI 112S/20000 G H A B C D E I Unit: mm A *1 B C D E *2 114.5+0.2/-0 (114.2+0.01/-0.01) 89 84 80 74 (Ef+0.01/-0.01) G H I 11 113 135+2/-2 ¥Note¥ *1) After shrink-fitting the rotor to the spindle, apply finish machining to outer surface of the rotor and each part bearings to be placed at the same process. Final finishing diameter is 114.2 +0.01/-0.01. *2)Before shrink-fitting, apply finish machining to rotor bore within the dimension of Ef +0.01/-0.01. "Ef" could be from 74.4 to 77 , so please choose the value. When machining, please refer to the reference figure below. *3) To assemble the shaft and rotor, apply shrink-fitting at maximum 200 degrees centigrade. Ideally, within 180 degrees centigrade. Interference should be 60 - 90 micro meters in the case of 20,000 min-1. *4)When you machine the rotor with coolant, please dry up after machining. *5) To balance the spindle, please prepare another ring on each side of the rotor. Be sure not cut or drill the rotor to balance the spindle. MACHINING ROTOR BORE (reference) Gauge FINISH DIMENSION OF SPINDLE *The parameter of Ef must be the same value as the value of rotor bore. 1.6S Rotor J Chuck Jig When machining the rotor bore, please hold the outer surface of a rotor with a jig shown above. If you hold the rotor bore, it may be deformed. Non-magnetic rings for balance http://www.Datasheet4U.com ...