LTC1734

LTC1734 Lithium-Ion Linear Battery Charger in ThinSOT FEATURES s s s s s DESCRIPTIO s s s s s s Low Profile (1mm) ThinSOTTM Package No Blocking Diode Required No Sense Resistor Required 1% Accurate Preset Voltages: 4.1V or 4.2V Charge Current Monitor Output for Charge Termination Programmable Charge Current: 200mA to 700mA Automatic Sleep Mode with Input Supply Removal Manual Shutdown Negligible Battery Drain Current in Shutdown Undervoltage Lockout Self Protection for Overcurrent/Overtemperature The LTC®1734 is a low cost, single cell, constant-current/ constant-voltage Li-Ion battery charger controller. When combined with a few external components, the SOT-23 package forms a very small, low cost charger for single cell lithium-ion batteries. The LTC1734 is available in 4.1V and 4.2V versions with 1% accuracy. Constant current is programmed using a single external resistor between the PROG pin and ground. Manual shutdown is accomplished by floating the program resistor while removing input power automatically puts the LTC1734 into a sleep mode. Both the shutdown and sleep modes drain near zero current from the battery. Charge current can be monitored via the voltage on the PROG pin allowing a microcontroller or ADC to read the current and determine when to terminate the charge cycle. The output driver is both current limited and thermally protected to prevent the LTC1734 from operating outside of safe limits. No external blocking diode is required. The LTC1734 can also ...